Pentax K-5 IIs Operating Guide

• If any irregularities occur during use, such as smoke or a strange odor, stop

use immediately, remove the battery or the AC adapter, and contact your

nearest PENTAX Service Center. Continued use can cause a fire or

electrical shock.

Caution

• Do not place your finger over the flash when discharging the flash. You may

burn yourself.

• Do not cover the flash with clothing when discharging the flash. Discoloration

may occur.

• Some portions of the camera heat up during use. There is a risk of low

temperature burns when holding such portions for long periods.

• Should the monitor be damaged, be careful of glass fragments. Also, be

careful not to allow the liquid crystal to get on your skin or in your eyes or

mouth.

• Depending on your individual factors or physical condition, the use of the

camera may cause itching, rashes or blisters. In case of any abnormality,

stop using the camera and get medical attention immediately.

Warning

• Always use the battery charger and AC adapter exclusively developed for this

camera, with the specified power and voltage. Using a battery charger or AC

adapter not exclusive to this camera, or using the exclusive battery charger or

AC adapter with an unspecified power or voltage can cause a fire, electric

shock, or camera breakdown. The specified voltage is 100 - 240V AC.

• Do not disassemble or modify the product. This can cause a fire or electrical

shock.

• If the generation of smoke or strange odor from the product or other

abnormality occurs, immediately discontinue using and consult a PENTAX

Service Center. Continued use can cause a fire or electrical shock.

• If water should happen to get inside the product, consult a PENTAX Service

Center. Continued use can cause a fire or electrical shock.

• If you see a lightning flash or hear thunder during use of the battery charger

or AC adapter, unplug the power plug and discontinue use. Continued use

can cause damage to the product, fire or electrical shock.

• Wipe off the power plug if it should become covered with dust. Accumulated

dust may cause a fire.

• To reduce the risk of hazards, use only CSA/UL certified power supply cord

set, cord is Type SPT-2 or heavier, minimum NO.18 AWG copper, one end

with a molded-on male attachment plug cap (with a specified NEMA

configuration), and the other is provided with a molded-on female connector

body (with a specified IEC nonindustrial type configuration) or the equivalent.

About the Battery Charger and AC Adapter

K-5 II_ENG.book Page 2 Wednesday, October 10, 2012 1:20 PM