Eaton PC2641-D-FF User Manual

© 2008 Eaton Corporation. All Rights Reserved. All specifications are subject to change without notice.

•

19” x 3.4” (2U) x 14.5” (recessed)

•

Approximate weight: 29 lbs.

•

2 unswitched outlets

•

12 switched outlets, 4 per phase

•

Main breaker power “on” to system and  

 

unswitched duplex

•

Power “on” to PH-X, -Y, -Z outlets

•

320V MOV L-N

•

Common Mode - Line to Ground

•

Differential Mode - Line to Line

•

Local: Power “on or off” to the switched  

 

outlets

•

Off: When breaker is “on” but this switch  

 

is in the “off” mode, you will have power  

 

to the unswitched outlets only

•

Remote: Power “on or off” to the  

 

switched outlets via a remote device

•

When using the Latching remote, the  

 

selection switch is wired for 
Remote/Off/Remote. There is no local  

 

control.

•

PH-X powers up immediately, followed  

 

4-seconds later by PH-Y, which is 
followed 4-seconds later PH-Z, then 
4-seconds later the sequenced remote 
activates the next system in line

•

PC2641-D/MTD and PC2641-D/LT
only models

•

Power cable with plug is attached to unit    
through the front panel cable grip

•

UL498 Listed electromagnetic breakers,  

 

with a long time delay curve, provide  

 

both manual on/off switching and trips  

 

automatically in an overload condition

•

Remote on/off and EPO control, 
EPO overrides remote and local control

•

Sequence Power Up additional 
equipment down line (standard on all units)

•

Latching remote - normally closed EPO, 
momentary start. Units with “LT” in 
part number, i.e. PC2641-D-LT or /LT