Manualsbrain.com
  1. Manuals
  2. Brands
  3. Panasonic
  4. PTLZ370E
  5. Operating Guide

Panasonic PTLZ370E Operating Guide

Download
Page of 120
Switching on/off
ENGLISH - 35
Basic Operation
Switching on the projector
Check external device connections before switching 
on the projector.
1)  Connect the power cord to the 
projector.
2)  Connect the power plug to an outlet.
3)  Press the <ON> side of the <MAIN 
POWER> switch to turn on the power.
▶
z
The power indicator <ON (G)/STANDBY (R)> 
illuminates or flashes red.
4)  Remove the lens cover.
▶
z
Be sure to remove the lens cover before 
starting projection.
5)  Press the power 
 button.
▶
z
The power indicator <ON (G)/STANDBY (R)> 
flashes green, and after a while, changes to 
illuminate, and then projection starts.
Attention
 
z
Using the projector while the lens cover is attached 
causes the device to heat up and can result in a 
fire.
Note
 
z
Confirm that [CONTROL PANEL] (when operating 
on the control panel) or [REMOTE CONTROLLER] 
(when operating with the remote control) is set 
to [ENABLE] from the [SECURITY] menu → 
[CONTROL DEVICE SETUP] (
 page 75).
When you set the [SECURITY] menu, entering a 
password is required. (
 page 73)
 
z
When switching on the projector, a small rattling 
sound may be heard or when the luminous lamp is 
lit, a tinkling sound may be heard, but this is not a 
malfunction.
 
z
During video projection, the cooling fan operates 
and makes a sound. This fan sound may change 
with ambient temperature and becomes louder 
when the lamp is turned on.
 
z
Setting the [PROJECTOR SETUP] menu → [LAMP 
POWER] (
 page 66) to [ECO] reduces operation 
sounds.
 
z
When the lamp is turned off and immediately 
turned back on again, the video may temporarily 
flicker slightly at the start of projection due to lamp 
characteristics, but his is not a malfunction.
 
z
When [ECO] is selected in [STANDBY MODE] 
under the [PROJECTOR SETUP] menu → [ECO 
MANAGEMENT] (
 page 67), the initial image may 
appear about ten seconds later than when set to 
[NORMAL].
 
z
If the direct power off function was used to set 
the <MAIN POWER> switch to <OFF> during 
projection, the next time the <MAIN POWER> 
switch is set to <ON> with the power plug 
connected to an outlet, the power indicator <ON (G)/
STANDBY (R)> will soon illuminate green and an 
image will be projected. (When the [PROJECTOR 
SETUP] menu → [INITIAL START UP] (
 page 65) 
is set to [LAST MEMORY] or [ON].)
3RZHULQGLFDWRU21*67$1'%<5!