Panasonic MCUG304 Operating Guide
10
M) TROUBLE SHOOTING GUIDE
TROUBLE
Motor fails to rotate
(no noise is heard at all).
(no noise is heard at all).
Motor runs but no suction.
Beater bar does not rotate.
CHECK POINT
• Mains plug connection.
• Mains plug fuse. (UK, IRL only)
• Thermal cut-out device may have
operated.
• Hose or each inlet clogged.
• Check dust indicator.
• Paper bag broken.
• Central filter.
• Check dust indicator.
• Paper bag broken.
• Central filter.
• Beater bar housing is clogged.
• Belt broken / loose.
• Belt broken / loose.
CAUSE / REMEDY
• Check that the mains plug is connected firmly and
mains outlet is ON.
• Check fuse and replace if blown.
• (See Thermal cut-out protection features below
described).
• If there is a blockage, remove it.
• If shows full, replace the paper bag.
• If paper bag is broken replace it.
• If the central filter is full of dust, clean or replace it.
• If shows full, replace the paper bag.
• If paper bag is broken replace it.
• If the central filter is full of dust, clean or replace it.
• If there is any obstruction, remove it.
• If the belt is broken or loose, replace it.
• If the belt is broken or loose, replace it.
Thermal Cut-out
This vacuum cleaner is fitted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of
the motor. When this happens, disconnect the cleaner from the socket outlet and check the dust bag as it may be full or
clogged with fine dust. Check for any other obstructions.
After replacing the dust bag or removing the obstruction, leave the vacuum cleaner to cool down until the thermal cut-out
resets after approximately 40 minutes.
Important: The thermal cut-out will not reset if the unit is not disconnected from the socket outlet.
This vacuum cleaner is fitted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of
the motor. When this happens, disconnect the cleaner from the socket outlet and check the dust bag as it may be full or
clogged with fine dust. Check for any other obstructions.
After replacing the dust bag or removing the obstruction, leave the vacuum cleaner to cool down until the thermal cut-out
resets after approximately 40 minutes.
Important: The thermal cut-out will not reset if the unit is not disconnected from the socket outlet.
Mains lead
IMPORTANT: If the mains lead becomes damaged, it must be repaired by Panasonic, authorised Service Centre or a qualified
IMPORTANT: If the mains lead becomes damaged, it must be repaired by Panasonic, authorised Service Centre or a qualified
person in order to avoid any hazard.
• Design and specifications may be changed without notice.
• Weight and dimensions shown are approximate.
• Weight and dimensions shown are approximate.
Before contacting your Panasonic service centre, check the following points:
NOTE: Failure to correctly maintain your product, for example regular cleaning and unblocking, may result in a
NOTE: Failure to correctly maintain your product, for example regular cleaning and unblocking, may result in a
charge if referred to a service agent for attention.
SPECIFICATIONS
Power source
Max. input
Nominal input
Dimensions (L x W x H)
Net weight
Dusting brush
Extension wand
Crevice nozzle
Power source
Max. input
Nominal input
Dimensions (L x W x H)
Net weight
Dusting brush
Extension wand
Crevice nozzle
MC-UG304
MC-UG302
230-240 V ~ 50 Hz
2000 W
1900 W
1600-1700 W
320 mm x 323 mm x 1045 mm
6.3 kg