Panasonic TH-47LFX30W Operating Guide
3
Power cable
To keep the waterproof property, do not loosen the part fi xing
the power cable to the main unit.
the power cable to the main unit.
Do not force to bend the protruding part of the power cable.
This may cause disconnection.
This may cause disconnection.
Protective coating
Cabinet aluminum parts and rear face are protected from corrosion with coating. Be careful not to damage
the surface. In case the surface is damaged, corrosion may occur from there.
the surface. In case the surface is damaged, corrosion may occur from there.
Installation position
• When direct sunlight is on the screen, black shadow may appear. This will disappear when the temperature
drops.
• To install the product long term in a special environment such as near a swimming pool, hot spring, or ocean, or in
a factory uses chemicals or gases, please consult your local Panasonic dealer beforehand.
• The product is equipped with cooling fans and air fi lters that need to be cleaned or replaced if covered with dust. Removing
or installing air fi lters requires space around the Display. With this in mind, provide adequate space when installing the Display.
[Height 7.874”/200 mm or greater, Width 7.874”/200 mm or greater, Depth 7.874”/200 mm or greater]
[Height 7.874”/200 mm or greater, Width 7.874”/200 mm or greater, Depth 7.874”/200 mm or greater]
d
d
d
d
d
d
d
d
d
d
d:7.874”/200 mm or greater
Installation conditions
To use the product in an environment where outdoor air temperature is lower than 39 °F (4 °C), make sure
to set the “Winter Mode” to “On”. The inside temperature is kept constant and the startup can be performed
smoothly.
to set the “Winter Mode” to “On”. The inside temperature is kept constant and the startup can be performed
smoothly.
Do not exhibit or use this product in a condition where water splashes on to it continuously for long time.
Always use the product at an ambient temperature in the range of 32 °F - 113 °F / 0 °C - 45 °C (during Winter
Mode: -4 °F - 113 °F / -20 °C - 45 °C).
Use the product at ambient temperatures up to 104 °F/40 °C at an installation site where the display screen
is exposed to sunlight.
Mode: -4 °F - 113 °F / -20 °C - 45 °C).
Use the product at ambient temperatures up to 104 °F/40 °C at an installation site where the display screen
is exposed to sunlight.
To install on a wall etc.
• Consult your dealer about fi ttings etc. beforehand.
• Choose a permanent position where the total weight of the product and fi ttings can be hold permanently. If the
• Choose a permanent position where the total weight of the product and fi ttings can be hold permanently. If the
strength of the position is not suffi cient, a serious accident such as fall may be caused.
• Do not install the product where a person can be hang or lean on, or a passer may collide into. Accident may be
caused.
• Take measures for tipping over and fall with an assumption of a fi tting or installation location failure.
• Installation strength may be degraded due to aging depends on the environment. Ask a installation professional to
• Installation strength may be degraded due to aging depends on the environment. Ask a installation professional to
inspect or repair regularly.
• When an abnormality or fault such as loose screw is detected, ask an installation professional or your dealer
immediately for repair.
• Panasonic will not be responsible for any damages from an accident such as defect of installation, improper use,
modifi cation, or natural disaster.
Precautions for Installation
Main unit bottom