Panasonic CZRWSU3 Operating Guide

Page of 24
9. Using the Remote Controller 
18
(EN)
•  Point the transmitter of the remote controller at the receiver. When the 
signal is received properly, it will beep one time. (It only beeps two times 
when the unit starts operating.)
•  The signal can be received at a distance of up to about 6 meters. This 
distance should be used only as a guide. It depends on battery strength.
•  Make sure nothing is between the remote controller and the receiver that 
could block the signal.
•  Do not leave the remote controller in direct sunlight, where the wind from 
the air conditioner can blow directly on it, or near any other heat source.
•  Take care not to drop, throw, or wash the remote controller with water.
•  The signal from the remote controller may not be received in rooms with 
rapid start fl uorescent lighting, inverter lights, plasma displays, LCD 
televisions (monitor), etc. For more information, please contact the 
distributor where the product was purchased.
Wall Mount Use
• Press   from the location 
you wish to mount the remote 
controller and make sure the 
signal is received properly.
•  Pull the remote controller 
forward to remove it.
10. For Best Results
Don’t get the remote controller too far away from the receiver.
This may cause a malfunction.
Be sure to keep the remote controller in the same room as the receiver.
Point the remote controller at the receiver.
When the signal is received properly, it will beep one time.
Avoid locating the remote controller where it is covered, such as 
behind a curtain.
Keep it out in the open.
Remote control 
holder
 
 
1
2
Fasten the remote 
control holder with 
screws.
Fitting the remote 
controller in the 
holder
Push
Fit in