Panasonic MCCG881C Operating Guide

25

Turn the power control to the highest setting and lift the nozzle 

off the fl oor. If the dust indicator turns red, the paper dust bag 

is full and requires replacing the paper dust bag.
NOTE:  If the paper dust bag is not properly installed, the dust 

cover will not close. Be sure to check that the paper 

dust bag is properly installed before operating the 

appliance, otherwise dust will leak out.

The paper dust bag can easily lay on the dust cover 

packing or clip between the bag collar and the body, 

so be sure to properly extend it into the body of the 

appliance.

D-1 

 Hold the dust cover catch and raise the dust cover until 

it clicks properly.

D-2 

 Remove the basket and throw away the paper dust bag.

D-3 

 Set the basket fi rst to the appliance and set a new paper 

dust bag to the  basket.

D-4 

Close the dust cover properly until you hear it click.

D-5 

  Inspect once a month.

Using an old toothbrush or similar tool,clean any dirt or 

lint from the brush.

D-6 

 Wipe with a soft cloth soaked with water.

Follow the procedure written below when the suction power is 

not restored after replacing a new paper dust bag.
D-7  

Remove the pre-motor fi lter.

Wash gently with water and then allow to dry in a 

shaded location.

 Return the pre-motor fi lter to its original position.

NOTE:  Make sure you remember to replace the fi lter. 

If the fi lter is not installed, it will cause motor 

failure.

 • 

 

Do not wash the fi lter in a washing machine or dry it 

with a dryer or other source of hot air.

D-10   Exhaust fi lter, is installed in the rear side of the 

appliance. This fi lter retains any small dust particles 

which may be present in the expelled air. It is advisable 

to change the fi lter once or twice a year, depending on 

use. To change the fi lter, hold the exhaust cover (as 

illustrated) and pull it out. After changed the fi lter, set the 

exhaust cover to its position (as illustrated).

IMPORTANT:  Never use the cleaner without the correct fi lters 

properly installed. Failure to do so may result in 

damage to the motor.

Check that the appliance is correctly plugged in and that the 

socket outlet is working. If the thermal cut-out device has 

operated, wait until it resets automatically after approximately 60 

minutes. 

If after having checked the above mentioned points, the 

appliance does not work, take it to an Authorized Service Centre 

to be repaired.

• Stop the appliance and unplug from the socket outlet.

•  Check whether the wands, hose and accessories are blocked or 

not. If they are blocked, remove the obstruction.

•  Check whether the paper dust bag is full. If it is full, replace it.

•  Check whether the pre-motor filter or exhaust filter is blocked 

with dust.

If they are blocked, clean them out or replace them.

Power source

230 V~50 Hz

Max. Input

1600 W

Nominal input

1300 W

Dimensions
(W x L x H)

312 mm x 489 mm x 243 mm

Net weight

6.5 kg

Extension wands

Telescopic

Dusting brush

√

Crevice nozzle

√

Upholstery nozzle

√

Paper dust bag (PACK 4/u.)

C-17H 

The model and serial number of this product may be found on the 

nameplate located at the underside of your cleaner. You should 

note the model and serial number in the spaces provided and 

retain this book as a permanent record of your purchase.

Model Number.  .............................................................................

Serial No.  ......................................................................................

Date Purchased.  ...........................................................................

Where Purchased.  ........................................................................