Panasonic PTD7600E Operating Guide

16

Every projector has its ID number and the ID number
of the controlling projector must be set to the remote
control in advance so that the user can operate the
remote control. The ID number of the projector is
set to “ALL” on shipping, and use the ID ALL
button of the remote control when using only a
single projector.

Press the ID SET button, and within five seconds, use
the NEXT button to set the number of the tens digit in
the ID number, which is already set in the projector,
and then use one of the numeric (0-9) buttons to set
the number of the units digit.
However, if the ID ALL button is pressed, the projector
can be controlled regardless of the ID number of the
projector (simultaneous control mode).

• If the ID SET button is pressed, the ID number goes

back to the one set before pressing the ID SET
button unless the NEXT button and a numeric button
are pressed within five seconds after the ID SET
button is pressed.

• Do not press the ID SET button accidentally or

carelessly because the ID number on the remote
control can be set even when no projector is around.

• Your specified ID number is stored in the remote

control unit unless another one is specified later.
However, the stored ID will be erased if the batteries
of the remote control are left exhausted.  When the
dry cells are replaced, set the same ID number again.