Panasonic PTD7600E Operating Guide

75

Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this
order. Add parameters according to the details of control.

The main unit is equipped with SERIAL terminals located in its terminal section on the side, and this terminal is
compliant with RS-232C. Also a serial output terminal is provided to enable plural projector control.

STX

C1

C2

C3

:

P1

P2

Pn

ETX

A D

I 1

I 2

;

• No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try

sending any command after that period has elapsed.

• When sending several commands, be sure to wait for a response from the projector before sending

the next command. When sending commands without parameters, a colon (:) is not necessary.

• If a wrong command is received, the projector will send an “ER401” command to the computer.
• Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.
• If a command is sent with a projector ID specified, the projector will return answer back only in the

following cases:

If it coincides with the projector ID,
ID specification is ALL and VPS-SYSTEM is the master, or
ID specification is group and Group is the master.

PC

D-Sub 9-pin (female)

Pin No. Signal name

TXD

RXD

GND

CTS
RTS

Description

NC

Send data

Receive data

Connected internally

Ground

NC

Connected internally

NC

Pin No. Signal name

RXD

TXD

GND

RTS
CTS

Description

NC

Receive data

Send data

NC

Ground

NC

Connected internally

NC

Synchronization method

Baud rate

Parity

Character length

Stop bit

X parameter
S parameter

Start-stop synchronization

9 600bps

None
8 bits

1 bit

None
None

PC