Panasonic NRB54X1 Operating Guide

Page of 31
13
English
Installation
Preparations
Maintenance
Remove all the packing materials and tapes. 
Wipe the inside of the refrigerator using a soft cloth which has been dipped in lukewarm water and then 
wrung out. 
Wash and completely dry the icebox before installing it. (Do not use a dish dryer, hair dryer or other appliance 
when drying.)
Connecting the power plug to the power outlet
When the power plug is connected to the power outlet, the temperature display starts 
flashing as shown in the figure on the right, and cooling starts inside the refrigerator. 
The temperatures displayed at this time are not the actual temperatures.
When the temperature of the fridge reaches 8 °C, the freezer reaches -12 °C and the 
Vitamin-Safe Zone (model NR-B53V1/B53VW1) reaches 5 °C, the temperature display 
stops flashing and lights, and it shows the actual temperature.
It takes about half a day to reach the set temperatures (when the room temperature is 
around 32 °C, there is no food inside the refrigerator, and the doors are closed).
Place the food inside the refrigerator only after it was confirmed that the refrigerator 
compartment had been cooled.
Notes:
 
● Cooling may take longer in the summer months or at other times when the room 
temperature is higher.
 
● While the temperature display is flashing, the alarm sounds to warn that the 
temperature has risen. The alarm can be turned off by pressing 
.
 
● If you need to unplug the refrigerator, wait at least 10 minutes before you plug it back 
in again. You might damage the compressor.
(model
NR-B53V1/B53VW1)
(model NR-B54X1)
The Ice/Water dispenser and automatic ice maker
Ice must first be made by the automatic ice maker before the Ice/Water dispenser can start dispensing ice. 
The automatic ice maker can make six cubes of ice at a time and about 60 cubes of ice a day (although this 
will differ depending on the prevailing conditions).
When using the ice maker for the first time, it takes about 8 hours for ice to be made.
Automatic ice-making stops as soon as the icebox becomes full.
Note:
 
● When using the Ice/Water dispenser and automatic ice maker for the first time, the water or ice may be 
discoloured or smell: this is normal and not indicative of any trouble. When water goes around through 
the water filter and pipes and other parts inside the refrigerator, these symptoms will disappear so keep 
supplying the water and removing the ice from Ice/Water dispenser until the discolouration/smell dissipates.  
In some homes, this procedure may have to be repeated a number of times.
How to remove the icebox
 
● Raise the icebox slightly, and pull the bottom part out toward you. (fig 1)
How to set the icebox
 
● First align its top part with the automatic ice maker, then push down its 
bottom part and insert it firmly into place below as far as it will go.
CAUTION
 
● Be sure to hold the icebox with both hands.
 
● Be sure to confirm that the icebox has been set firmly 
when installing.  
(Fall of icebox may cause injury or trouble.)
When the icebox can not be installed correctly
 
● Insert the icebox to the original position completely after rotating the knob 
90 degrees which located in the back of icebox as indicated in fig 2.
1
2
fig 1
fig 2