Panasonic ER5209 Operating Guide

English

Charging

Char

1. Set the switch

to “0•charge”,

and insert the

power cord into

the clipper.

2. Connect the AC

adaptor into an

outlet. The

charging

indicator lamp

will light up.

3. Disconnect the

AC adaptor

from an outlet

when charging

is completed.

• The charging time is 8 hours.
• 1 full charge will provide approximately 40 minutes of continuous

operation.

Inserting the attachment

1 20/30/40mm, 50/60/70mm comb attachments

1. Adjust the attachment to the desired

trimming height by sliding it until it

clicks while the switch is in “0•charge”.

• Set the attachment to the correct position.

Otherwise you cannot set the switch to “1”.

• Actual hair length will be a little longer than

the height you set.

1 3/6mm, 9/12mm, 15/18mm comb attachments

6mm

3mm

9mm

12mm

18mm

15mm

3/6mm

9/12mm

15/18mm

1. Select the

cutting heights

indicated on the

insides and

sides of the

attachments.

2. Mount the

attachment to

the clipper as

illustrated.

3. To remove the

attachment

from the clipper

1 Natural cutting attachment

This attachment allows thinning of hair by cutting
from the inner side. Hair volume is reduced, and hair
tips are trimmed at various lengths to leave a natural
look. Desirable hair lengths for this attachment:
30 mm-70 mm (hair lengths shorter than 30 mm may
be too short to cut in some situations.)

1 Thinning Attachment

1. Insert the attachment

over the trimming blades

until it clicks as

illustrated.

2. To remove the

attachment, push both

sides while pulling the

attachment.

ER5209(EU).indb 3

2007/02/22 18:09:48