Panasonic CSHZ9RKE4 Installation Guide
6
Indicator
ECONAVI
To optimise energy saving
MODE
To select operation mode
HEAT - To enjoy warm air
COOL - To enjoy cool air
DRY
COOL - To enjoy cool air
DRY
- To dehumidify the environment
FAN
-
To circulate air in the room
AUTO - For your convenience
+8/10°C
HEAT
To use maintenance heating
• Maintain indoor temperature at 8/10°C. Fan
switches to high fan speed automatically.
• This operation overwrite the operation mode and
could be cancelled by pressing
MODE
.
• Defrost operation at outdoor unit
will result in sudden cold air from
indoor unit. Eliminate cold air with
heat mode.
indoor unit. Eliminate cold air with
heat mode.
POWERFUL/QUIET
To switch between
powerful & quiet
powerful & quiet
QUIET
POWERFUL
NORMAL
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
How to use
Auto OFF/ON button
AUTO
OFF/ON
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
• To use in AUTO mode, press the button once.
• To use in AUTO mode, press the button once.
• To use in COOL mode, press and hold the button until 1 beep is heard, then
release.
• To use in HEAT mode, press and hold the button until 1 beep is heard, then
release. And press again until 2 beeps, then release.
• Press the button again to turn off.
Sunlight sensor and
remote control receiver
remote control receiver
TIMER
+8/10°C HEAT
DEICE
POWERFUL
QUIET
POWER
(Green)
(Green)
(Blue)
(Orange)
(Orange)
(Orange)
(Green)
FAN SPEED
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• In HEAT mode, if manual fan speed caused
discomfort, set the fan speed to AUTO or lower
the fan speed.
10˚C
8˚C
MODE
AIR CONDITIONER
Remote control display
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
remote control to
default setting.
Not used in normal
operations.
operations.
F570014_YA0515-0.indb 6
F570014_YA0515-0.indb 6
30/6/2015 6:47:44 PM
30/6/2015 6:47:44 PM