Panasonic ERGC71 Operating Guide
10
English
Preparation
Charging the clipper
• Make sure that the clipper is turned off.
1
Connect the appliance plug to the
appliance socket.
appliance socket.
2
Plug in the adaptor into a
household outlet.
household outlet.
• Charging is completed after approx.
8 hours.
• Check that the charge indicator lamp
(
) glows.
1
2
3
Disconnect the adaptor after charging is completed.
(for safety and to reduce energy usage)
The charge indicator lamp (
The charge indicator lamp (
) continues to glow after
charging is complete. There is no indication to show that
“charging is complete”.
“charging is complete”.
Notes
• If there is crackling noise on radios or other devices while
charging, charge the clipper using a different household outlet.
• When the appliance is not used for 6 months or more, the battery
will weaken (leak battery fluid, etc.). Fully charge the battery
once every 6 months.
once every 6 months.
• When charging the clipper for the first time or when it has not
been in use for more than 6 months, the charging time may
change or the lamp on the main body may not glow for a few
minutes. Please charge it for more than 16 hours in such cases.
change or the lamp on the main body may not glow for a few
minutes. Please charge it for more than 16 hours in such cases.
• Recommended ambient temperature for charging is 0 °C – 35 °C.
Battery performance may decrease outside of the recommended
temperature.
temperature.
• A full charge supplies enough power for approximately
40 minutes of use.
The operating time may differ depending on the frequency of
use, the operating method and the ambient temperature.
The operating time may differ depending on the frequency of
use, the operating method and the ambient temperature.
• You can charge the battery before it is completely discharged.
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
Using the clipper
• Make sure that the clipper is turned off.
• Apply the oil to the clipper before and after each use.
(See page 15.)
• The appliance may not operate in an ambient temperature
approximately 0 °C or lower.
1
Mount the desired comb attachment and adjust
the trimming height as needed. (See page 11.)
the trimming height as needed. (See page 11.)
• It can also be used without the comb attachment.
(Trimming height: approx. 0.5 mm)
2
Slide the power switch on the main body
to the “ ” position to turn on the power.
to the “ ” position to turn on the power.
Trimming hair
(See page 12.)
Trimming beard
(See page 13.)
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it.
charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly or
stop, even with the AC operation. In this case, charge the battery
for 3 minutes or more.
for 3 minutes or more.
• The battery will be discharged, even with the AC operation.
ER-GC71_51_EU.indb 10
2016/01/28 17:44:56