Panasonic TY-ST58PF20 Operating Guide

Page of 122
19
3.  Fitting to the stand
Note
Before fitting the plasma display, make sure to lock the 
casters.
1.  
Fitting plasma display
   Engage the upper insulation spacers of the 
plasma display with the cutouts at the top of the 
mobile stand, and slowly lower the plasma display 
into place.
   While lifting the plasma display slightly, insert the 
bottom insulation spacers into the holes at the 
lower end of the mobile stand, and then lower the 
plasma display straight down into place.
Caster locked
Push the 
bottom of 
the lever
Push the 
top of the 
lever
Caster unlocked
Locking and unlocking the casters
2.  
Fixing of the plasma display
 
 Firmly tighten the two screws for securing unit  in 
the holes of the top bracket for plasma display 
 .
 
(Tightening torque: 1.5 to 2 N•m)
Note
Make sure to fit the screws for securing unit  on the left 
and right to prevent the plasma display from coming off.
Mark A: 58-inch
Mark B: 42/50-inch
No mark: Spare
A B
B A
A B
B A
CAUTION
If the plasma display is lifted too much, it will fall down 
and personal injury may result.
English
Cutout at top
Upper insulation spacer
Hole at bottom
Lower 
insulation 
spacer
  
Holes for screws for securing unit
(Use screw holes above cutouts 
with insulation spacers inserted)
Screw for securing unit 