Panasonic KXMB1530E Operating Guide

Page of 92
10.1 Report messages (KX-MB1520/KX-MB1530 only)
To indicate the unit’s fax transmission/reception status, one of the following messages will be printed on the sending
and journal reports (page 39).
Message
Code
Cause & Solution
COMMUNICATION ERROR
40-42
46-72
FF
R A transmission or reception error occurred. Try
again or check with the other party.
43
44
R A line problem occurred. Connect the telephone line
cord to a different socket and try again.
R An overseas transmission error occurred. Try using
the overseas mode (feature #411 on page 57).
DOCUMENT JAMMED
-----
ERROR-NOT YOUR UNIT
53
54
59
70
R A transmission or reception error occurred because
of a problem with the other party’s fax machine.
Check with the other party.
JUNK FAX PROH. REJECT
-----
R The junk fax prohibitor feature of this unit rejected
fax reception.
MEMORY FULL
-----
R The memory is full of received documents due to a
lack of recording paper or a recording paper jam.
Load paper (page 13) or remove the jammed paper
(page 77).
R If the PC fax setting (feature #442 on page 60) is set
to “ALWAYS”, check the connection between the
computer and the unit.
NO DOCUMENT / FAILED PICKUP
-----
R The document was not fed into the unit properly.
Re-insert it and try again.
R The ADF top cover is not fully closed. Push firmly on
the front and rear edges of the ADF top cover, and
then feed the document again.
OTHER FAX NOT RESPONDING
-----
R The other party’s fax machine is busy or has run out
of recording paper. Try again.
R The other party’s fax machine rings too many times.
R The other party’s machine is not a fax machine.
Check with the other party.
R The number you dialled is not in service.
PRESSED THE ‘Stop’ KEY
-----
R MStopN was pressed and fax communication was
cancelled.
THE COVER WAS OPENED
-----
R The front cover was opened. Close it and try again.
OK
-----
R Fax transmission or reception was successful.
67
10. . Help
10. Help