Panasonic MCCG677K Operating Guide

• Caution for AC Mains Lead (UK and Republic

• Important safety instructions for the user ..................... 2

• Specifications ................................................................... 5

•  Vacuum cleaner Consumables /Accessories

2

• This appliance is not intended for use by young children or infi rm person without supervision.
• Do not use the appliance if the mains lead or plug is damaged or faulty.
•  This  appliance is provided with a mains lead and if this becomes damaged, it must be repaired by an Authorized Service Centre 

or a qualifi ed person in order to avoid any hazard.

• Unplug from the socket when not in use and before cleaning the appliance or undertaking maintenance operations. 
• Turn off the appliance before removing the plug. Do not pull on the mains lead, always pull on the plug body itself
• Do not handle plug or vacuum cleaner with wet hands.
• Do not use wet fi lters after wash, make sure they are completely dry to avoid damaging the cleaner.
• Do not vacuum fl ammable or combustible substances, neither use in areas where they may be present.
• Do not vacuum hot ash, embers or large and sharp objects.
• Do not vacuum water or other liquids. 
• Keep the vacuum cleaner away from heat sources such as radiators, fi res, direct sunlight, etc.
•  This vacuum cleaner is fi tted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of the 

motor. When this happens, disconnect the cleaner from the mains socket and check the dust compartment and fi lters as they 
may be full or clogged with fi ne dust. Check for any other obstructions in the hose or tube.  After removing the obstruction, leave 
the cleaner to cool down until the thermal cut-out resets after approximately 60 minutes.

This appliance is supplied with a moulded three pin mains plug for your safety and convenience.

A 13 amp fuse is fi tted in this plug.

Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amps and that it 

is approved by ASTA or BSI to BS1362. 

Check for the ASTA mark        or the BSI mark       on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is refi tted when the fuse is replaced.

If you lose the fuse cover the plug must not be used until a replacement cover is obtained.

A replacement fuse cover can be purchased from your local Panasonic Dealer.

IF THE FITTED MOULDED PLUG IS UNSUIT ABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE 

SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 

13 AMP SOCKET.

If a new plug is to be fi tted please observe the wiring code as shown below.

If in any doubt please consult a qualifi ed electrician.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

 

Blue : Neutral

 

Brown : Live

As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying 

the terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the terminal in  the plug which is marked with the letter N or

coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or 

coloured RED.

Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter 

E or the Earth Symbol   

• There are two types of the supplied AC Mains Lead  A  and  B  as shown below.

1 Open the fuse compartment with a screwdriver.

2 Replace the fuse and fuse cover if detachable.

TYPE  A

TYPE  B