Panasonic MCCG677K Operating Guide

5

Turn the power control to the highest setting and lift the 

nozzle off the fl oor. If  the dust indicator turns red, the dust 

bag is full and requires replacing the dust bag.

NOTE:  If the dust bag is not properly installed, the cover will 

not close. Be sure to check that the bag is properly 

installed before operating, otherwise dust will leak 

out.

 

   The dust bag can easily lay on the dust cover packing 

or clip between bag collar and body, so be sure to 

properly extend it into the vacuum cleaner body.

D-5 

 After removing the brush cover with a coin, remove 

the beater bar from the belt.

 

 Then cut across threads, strings, hairs, etc. from the 

beater bar with a pair of scissors. (Removal as per 

reverse procedure)

 

NOTE: Take care not to cut the brush.

 

Do not wash in water.

D-6 

 Wipe with a soft cloth soaked with water.

Follow the procedure written below when the suction power 

is not restored after replacing a new bag.
D-7  

NOTE:  Make sure you remember to replace the fi lter. If the 

fi lter is not installed, it will cause motor failure.

•  Do not wash the fi lter in a washing machine or dry it with a 

dryer or other source of hot air.

•  The plug must be removed from the socket-outlet before 

•  To avoid injury, keep your fi ngers and hands away from 

•  DO NOT use hot air or hot surface to dry fi lters. Keep at 

•  IMPORTANT: Before re-installing the washable fi lters, 

 

  Exhaust fi lter is installed in the rear side of the 

vacuum cleaner.

 

  This fi lter retains any small dust particles which 

may be present in the expelled air. It is advisable to 

change the fi lter once or twice a year, depending on 

use. To change the fi lter, hold the exhaust cover (as 

illustrated) and pull it out.

 

  After changed the fi lter, set the exhaust cover to its 

position (as illustrated).

NOTE: 

IMPORTANT:  Never use the cleaner without the correct 

fi lters properly installed. Failure to do so may 

result in damage to the motor.

Check that the appliance is correctly plugged in and that the 
electrical socket is working. In case that the thermal cut-out 
device has operated, wait until it resets after approximately 60 
minutes. 
If after having checked the mentioned points, the cleaner does 
not work, take it to an Authorized Service Centre to be repaired.

• Stop the cleaner and unplug from the socket.
•  Check whether the wands, hose and accessories are blocked or 

not. If they are blocked, remove the obstruction.

•  Check that the dust bag is full. If it is full, replace it to a new 

one.

•  Check that Pre-motor Filter or Exhaust Filter is blocked with 

dust. If they are blocked, clean them out or replace.

Power source

230-240 V~50 Hz

Max. Input

1400 W

Nominal input

1100-1200 W

Dimensions
(W x L x H)

280 mm x 430 mm x 260 mm

Net weight

5.1 kg

Extension wands

Telescopic

Crevice nozzle

√

Dusting brush

√

REMINDER FOR CUSTOMER
The model and serial number of this product may be found on the 
nameplate located at the underside of your cleaner. You should 
note the model and serial number in the spaces provided and 
retain this book as a permanent record of your purchase.
Model Number.  .............................................................................
Serial No.  ......................................................................................
Date Purchased.  ...........................................................................
Where Purchased.  ........................................................................