Panasonic CWSC120AA Operating Guide

CLOSE VENT

OPEN

Electrical Work
=

• Always use at the rated voltage and with a specific air conditioning circuit.
• Some installation locations may require installation of a shortcircuit breaker.
• A 16 Ampere time delay fuse or circuit breaker is required.
• Nominal cross sectional area of power supply wire must be 3 core x 1.5 mm

or above.

• The power supply must be from an independent circuit.
• All electrical installation must be made in accordance with local wiring and safety regulations wherever applicable.
• There must be a double pole switch with minimum 3 mm contact gap in the fixed installation circuit. (Applicable for models

without power supply plug only)

• Please consult your dealer concerning installation requirements.

•

!"#$%&'($)*+%,-.

•

!"#$%&' !()*+

•

!16 !"#$%&'()*+,

•

!"#$%&'()*+ 3 =x 1.5 !"#$%

•

!"#$%&'()

•

!"#$%&'()*+,- ./"0123

•

!"#$%&'()*+,-./0123 !"#$%&'()*+,-./0 12%3

•

!"#$%&'()*+,-.

Remove The Air Filter Procedures
=

!"#$%&'

CLOSE VENT

OPEN

1 Pull up the front intake grille.

2 Lift up the front intake grille at 45° until it is supported by the

stopper.

3 Tilt up and pull out the air filter by the holder.

1 !"# $%&'()

2 !"# $%&'()45° !"#$%&'

3 !"#$%&'()*+,-./012

Stopper

Å Reattach the front intake grille

!"# $%&'(

Ä Insert the air filter

!"#$

CLOSE VENT

OPEN

NOTE: A “click” sound can be heard when
the front intake grille is pushed down.

!"#$%&'“”

Slide the front intake grille slightly to the right to
reattach the tabs and then push down to close tight.
!"#$%"&'()*+,-./0123'456

Lift up to

about 90°
!

90°

CW-PC120AA(09-13)

1/30/01, 11:00 AM