Panasonic EW-DE92 Operating Guide

Page of 336
12
English
► About soft start function (For WHITE mode only)
The toothbrush will gradually reach the selected speed and 
vibration approximately 2 seconds after it starts operating.
► About the 30-second brushing notification timer function
The timer will signal once at 30‑second intervals to indicate the 
brushing time for each part of your mouth. It will signal twice at 
2‑minute intervals to indicate the recommended total brushing time.
It is important to brush each area in the same sequence and with 
the same amount of time, every time you brush, to uniformly brush 
and clean your teeth. 
Use the 30‑second brushing notification timer function wisely so 
there will be no missed spot in your mouth.
• Divide your teeth into 4 parts (upper 
and lower, left and right), and brush 
one part in order such as “(1) front of 
the teeth”, “(2) biting plane of the 
teeth”, and “(3) back of the teeth” 
spending 30 seconds. 
Brush the other parts in the same 
manner, and brush your whole mouth 
in about 2 minutes. 
(1)(2)(3)
► About mode storage function
This function stores the previously selected mode of operation, 
allowing the same mode to be used again.
Mode storage is reset if the unit has discharged and has been 
unused for a long period of time, or if the battery has been 
completely drained.
After charging, the product starts in WHITE mode, however this is 
not a malfunction.
Using the toothbrush
• If dried toothpaste or water stains have adhered to the ion panel, 
the very weak electric current may be unable to pass into the oral 
cavity. Please clean the ion panel.
1
1
Place the brush head firmly onto
the toothbrush shaft.
• As shown in the picture, align the front of 
the electrode section of the ionic stain 
care brush or silicone brush with the main 
unit.
• Attaching or removing diagonally or while 
twisting may cause the brush head or the 
main unit to become damaged.
• The toothbrush shaft will move when a 
force is applied. This is required for 
operation, and is not a malfunction.
1
• There will be a small gap between the 
brush head and the main unit.
2
2
Grasp the main unit.
• The very weak electric current 
may not pass into the oral 
cavity if the toothbrush is held 
in the same way as a pen so 
that your hand does not touch 
the ion panel. 
Please grasp the main unit as 
shown in the figure, so that 
your hand comes in contact 
with the ion panel.
EW-DE92_EU.indb   12
2013/10/10   18:23:25