Panasonic SC-PM38 Operating Guide
ENGLISH
RQTX0215
5
Batteries
Use a manganese dry battery or an alkali dry battery.
Insert so the poles (+ and –) match those in the
remote control.
Remove if the remote control is not going to be used
for a long period of time.
Store in a cool, dark place.
Do not heat or expose to flame.
Do not leave the batteries in an automobile exposed to
direct sunlight for a long period of time with doors and
windows closed.
Mishandling of batteries in the remote control can
cause electrolyte leakage, which may cause a fire.
Use a manganese dry battery or an alkali dry battery.
Insert so the poles (+ and –) match those in the
remote control.
Remove if the remote control is not going to be used
for a long period of time.
Store in a cool, dark place.
Do not heat or expose to flame.
Do not leave the batteries in an automobile exposed to
direct sunlight for a long period of time with doors and
windows closed.
Mishandling of batteries in the remote control can
cause electrolyte leakage, which may cause a fire.
Use
Aim at the remote control sensor, avoiding obstacles,
at a maximum range of 7 m directly in front of the unit.
Refer to page 6 for remote control signal sensor
position.
Aim at the remote control sensor, avoiding obstacles,
at a maximum range of 7 m directly in front of the unit.
Refer to page 6 for remote control signal sensor
position.
•
•
•
•
•
•
•
•
•
•
•
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer’s
instructions.
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer’s
instructions.
When the unit is first plugged in, a demonstration of its
functions may be shown on the display.
If the demo setting is off, you can show a demonstration
by selecting “DEMO ON”.
Press and hold [g, –DEMO].
The display changes each time the button is held down.
functions may be shown on the display.
If the demo setting is off, you can show a demonstration
by selecting “DEMO ON”.
Press and hold [g, –DEMO].
The display changes each time the button is held down.
While in standby mode, select “DEMO OFF” to reduce
power consumption.
power consumption.
DEMO OFF
DEMO ON
FM outdoor antenna
75 Ω coaxial cable
(not included)
(not included)
AM outdoor antenna
AM outdoor antenna
(not included)
(not included)
AM loop antenna
(included)
(included)
Never use an outdoor antenna during a lightning storm.
You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire
horizontally along a window or other convenient location.
You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire
horizontally along a window or other convenient location.
•
•
•
•
•
•
•
FM outdoor antenna (not included)
DEMO
VOLUME
VOLUME
OPEN/CLOSE
_
+
/
iPod
/
USB
/
CD
FM/AM
[g, –DEMO]
R6/LR6, AA
Place this side in before the other side
Do not:
mix old and new batteries;
use different types of batteries at the same time;
take apart or short-circuit;
attempt to recharge alkaline or manganese batteries;
use batteries if their covering has been peeled off.
use different types of batteries at the same time;
take apart or short-circuit;
attempt to recharge alkaline or manganese batteries;
use batteries if their covering has been peeled off.
•
•
•
•
•
•
•
•
•
Optional antenna connections
5 to 12 m
Simple setup
(continued)
Preparing the remote control
DEMO function
SC-PM38EB.indb 5
2/25/2009 4:52:14 PM