Panasonic KXHNS102 Operating Guide
Part names and
functions
A
B
C
D
E
N
Used to confirm the status of the
sensor or register the sensor to
the hub.
sensor or register the sensor to
the hub.
LED indicator
You can press M
N and check the
LED indicator to confirm the sensor’s
status.
status.
Indicator
Status
Green, lit
No motion detected
Red, lit
Motion was detected
Indicator
Status
Red,
blinking
blinking
Sensor is out of range
of the hub
of the hub
Green,
blinking
slowly
blinking
slowly
Registration mode
(You pressed and held
M
(You pressed and held
M
N)
Off
No battery power
Note:
R The LED indicator does not indicate
R The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 8).
been registered (page 8).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The motion sensor is battery
powered.
The motion sensor is battery
powered.
3
Registration
Required only if the motion sensor
was purchased separately (i.e.,
not as part of a bundle).
Required only if the motion sensor
was purchased separately (i.e.,
not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the motion sensor in the
desired location.
Install the motion sensor in the
desired location.
For assistance, please visit http://shop.panasonic.com/support
7
Setup
HNS102_(en_en)_1008_ver.201.pdf 7
2015/10/19 10:05:19