Panasonic KXMB2061E Operating Guide

Page of 156
Display
Cause & Solution
“REMOVE DOCUMENT”
The document is jammed. Remove the jammed document (page 130).
R Attempted to send or copy a document longer than 600 mm using the
automatic document feeder. Press MStopN to remove the document. Divide
the document into two or more sheets and try again.
“REMOVE PAPER IN INPUT
TRAY #2”
R The recording paper is installed in the manual input tray when trying to
receive faxes or print reports. Remove the recording paper from manual
input tray.
“REPLACE DRUM CHANGE
SUPPLIES”
R The drum cartridge’s service life is finished. Replace the drum cartridge and
the toner cartridge immediately.
“RX MEMORY FULL”
R The memory is full of received documents due to a lack of recording paper
or a recording paper jam. Load paper (page 16) or remove the jammed
paper (page 125).
– check the connection between the computer and the unit.
– check that the computer is turned ON.
– view, print or save the received fax documents using the web browser
on the computer connected via the LAN, and then erase the
unnecessary documents (page 67).
– turn the setting to “OFF”. The fax documents stored in memory will be
printed automatically.
“SCANNER POSITION
ERROR”
R There is something wrong with the scanner position. Turn the power switch
OFF, then ON. If the problem cannot be solved, contact our service
personnel.
“SERIAL ERROR”
R There is something wrong with the unit. Contact our service personnel.
“SUBSCRIBE TO CALLER ID”
R You must subscribe to use Caller ID service. Contact your service provider/
telephone company for service availability. Once you receive caller
information, this message will not be displayed.
“TONER EMPTY”
“CHANGE SUPPLIES”
R The toner is empty. Replace the toner cartridge immediately.
“TONER LOW”
“CHANGE SUPPLIES”
R The toner is reaching the end of its life. You will need to replace the toner
cartridge soon.
“TOP COVER OPEN”
R The top cover is open. Close it.
“TRANSMIT ERROR”
R A transmission error occurred. Try again.
13.2.2 Cordless handset
Display
Cause & Solution
“Error”
R Recording was too short. Try again.
“Failed”
R Phonebook copy failed. Confirm the destination unit is in standby mode and
try again.
“Incomplete”
R The destination unit’s phonebook memory is full. Erase the unnecessary
phonebook items from the destination unit and try again.
“Memory Full”
R The cordless handset’s phonebook memory is full. Erase unnecessary
“Messages Full”
R There is no room left in memory to record voice messages. Erase
111
13. Help