Panasonic KXMB2061E Operating Guide
4. Press MCN or MDN to select “Ringer Volume”. A
5. Press MCN or MDN to select the desired volume. A
A M
N
Note:
R When receiving a call, you can adjust the ringer
R When receiving a call, you can adjust the ringer
volume by pressing MCN or MDN.
R When the ringer volume is turned OFF, is
displayed and the cordless handset does not ring for
outside calls.
However even when the ringer volume is set to OFF,
the cordless handset rings:
– at the low level for alarm (page 99) and intercom
outside calls.
However even when the ringer volume is set to OFF,
the cordless handset rings:
– at the low level for alarm (page 99) and intercom
Cordless handset receiver volume
While using the receiver, press MCN or MDN.
While using the receiver, press MCN or MDN.
Speaker volume
While using the speakerphone, press MCN or MDN.
While using the speakerphone, press MCN or MDN.
2.8 Date and time
We recommend you to set the date and time. The other
party will receive your unit’s date and time as the header
information.
party will receive your unit’s date and time as the header
information.
2.8.1 With the base unit
MSetN
MMenuN MFNMEN
MFaxN
1
MMenuN A MBNM1NM0NM1N A MSetN
2
Enter the current date/month/year by selecting 2
digits for each.
Example: 3 August, 2010
M0NM3N M0NM8N M1NM0N
digits for each.
Example: 3 August, 2010
M0NM3N M0NM8N M1NM0N
3
Enter the current hour/minute by selecting 2 digits for
each.
Example: 10:15 PM (12 hour clock format)
1. M1NM0N M1NM5N
2. Press MGN repeatedly to select “PM”.
Press MGN repeatedly to select “AM” or “PM”, or
24-hour time entry.
each.
Example: 10:15 PM (12 hour clock format)
1. M1NM0N M1NM5N
2. Press MGN repeatedly to select “PM”.
Press MGN repeatedly to select “AM” or “PM”, or
24-hour time entry.
4
MSetN
5
Press MMenuN to exit.
Note:
R To check the current date and time setting, press
R To check the current date and time setting, press
MFaxN to temporarily change the unit to the fax mode.
R Your unit’s date and time will be used as the header
information for the following:
– When sending as an attached file to an email
– When sending as an attached file to an email
destination directly from this unit (Scan to email
address) (page 38).
address) (page 38).
R If the date and time is not set correctly, the other party
will receive an incorrect date and time as their
header. This may confuse the other party.
header. This may confuse the other party.
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
If you have subscribed to a Caller ID service
The date and time will be automatically set according to
the received caller information.
R If the time has not previously been set, Caller ID will
The date and time will be automatically set according to
the received caller information.
R If the time has not previously been set, Caller ID will
not adjust the clock.
27
2. Preparation