Panasonic SC-AK340 Operating Guide
17
RQT8043
RQTV0066
LANG - 5
LANG - 4
FRANÇAIS
DANSK
DEUTSCH
Troubleshooting guide
Before requesting service, make the checks below. If you can’t fi x the system as described below, or if something not
listed here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact
your dealer.
listed here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact
your dealer.
Reference pages are shown as black circled numbers
4.
Common problems
Although the unit is in standby
mode, the display lights up and
changes continuously.
mode, the display lights up and
changes continuously.
Turn off the demo function.
5
If you set the clock, demo function will be turned off automatically.
%
No sound.
Sound stops.
Sound stops.
Turn the volume up.
Switch off the unit, determine and correct the cause, then switch the unit on.
Causes include shorting of the positive and negative speaker wires, straining
of the speakers through excessive volume or power, and using the unit in a hot
environment.
Switch off the unit, determine and correct the cause, then switch the unit on.
Causes include shorting of the positive and negative speaker wires, straining
of the speakers through excessive volume or power, and using the unit in a hot
environment.
Sound is unfi xed, reversed or
comes from one speaker only.
comes from one speaker only.
Check the speaker connections.
4
Humming heard during play.
An AC mains lead or fl uorescent light is near the cables. Keep other appliances
and cords away from this unit’s cables.
and cords away from this unit’s cables.
“ERROR” is displayed.
Incorrect operation performed. Read the instructions and try again.
“– –:– –” appears on the display at
standby mode.
standby mode.
You plugged the AC mains lead in for the fi rst time or there was a power failure
recently.
Set the time.
recently.
Set the time.
%
“F61” is displayed.
Check and correct the speaker cords connection.
4
If this does not fi x the problem, there is a power supply problem. Consult the
dealer.
dealer.
Listening to the radio
Noise is heard.
The stereo indicator fl ickers or
doesn’t light.
Sound is distorted.
The stereo indicator fl ickers or
doesn’t light.
Sound is distorted.
Use an outdoor antenna.
5
A beat sound is heard.
Turn the TV off or separate it from the unit.
A low hum is heard during AM
broadcast.
broadcast.
Separate the antenna from other cables and cords.
When there is a television set nearby
The picture on the TV disappears
or stripes appear on the screen.
or stripes appear on the screen.
The location and orientation of the antenna are incorrect. If you are using an
indoor antenna, change to an outdoor antenna.
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV
set from the unit.
indoor antenna, change to an outdoor antenna.
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV
set from the unit.
Using the cassette deck
Poor quality sound.
Clean the heads.
(
Recording is not possible.
If the erasure prevention tabs have been removed, cover the holes with adhesive
tape.
tape.
#
(Continued on next page)
RQTV0066-B.indd 17
RQTV0066-B.indd 17
11/16/05 9:37:42 AM
11/16/05 9:37:42 AM