Panasonic SA-XR58 Operating Guide

Page of 40
ENGLISH
RQTV0156
17
Before playback
Speaker output and level
Adjust the level of the speakers so they are the same apparent level as the front speakers from the seating area.
Speaker level is adjusted during auto speaker setup. Do the following only if you find the level unsatisfactory.
To turn on SPEAKERS A.
 
Press 
1
The unit does not output the test signal if only SPEAKERS B is 
on.
If you have bi-wired your front speakers (
 page 
13), make sure you have selected “YES” for the 
“LR BI-WIRE setting” (
 page 27).
 
 
Press 
or 
Press 
 to output the test signal.
The signal is output from each speaker in order for 
about two seconds each:
2
L
CRRSSBRSBLLSSUBW
or
 L
CRRSSB
1
LSSUBW
1
If you connect one surround back speaker only (the left 
surround back speaker)
Set speakers volume to the level you would normally use.
 
Press 
Volume range:
-- dB (minimum), -79 dB to 0 dB (maximum)
3
Press 
 to select the speaker channel to adjust.
Press 
 to adjust the level 
to the same apparent level as the 
front speakers.
Repeat steps 4 and 5 for each speaker channel.
Adjustment range:
-20 dB to +10 dB (Factory setting: 0 dB )
For the subwoofer
 (SUBW)
MIN (minimum) 
 1 to 29  MAX (maximum)  
(Factory setting:
 20 )
The test signal is output only from the speaker you are adjusting in 
steps 4 and 5. Test signal for connected speakers resumes after 2 
seconds.
4
5
Press 
 to stop the test signal.
6
Speaker abbreviations
L:
 Front left 
C: Center 
R: Front right
RS: Surround right
LS: Surround left
SBR: Surround back right
SBL: Surround back left
SB: Surround back (If you connect 
one surround back speaker)
SUBW: Subwoofer
SPEAKERS A are on
SPEAKERS A and B are on
SPEAKERS
A
A
SPEAKERS
A
B
SPEAKERS
SPEAKERS
A
SPEAKERS
B
A
B
SPEAKERS
BI-WIRE
TEST
AUTO
VOLUME
LEVEL
TEST
AUTO
or
Automatic speaker detection
Automatic speaker detection is performed during auto speaker setup. Do the following only if you want to check speakers’ status, and 
not other settings.
Turn on the unit.
 
Press 
The standby indicator goes off when you turn on the unit.
Start automatic speaker detection. 
 
Press 
 at the same time.
1
2
SPEAKERS
A
B
AUTO DETECTOR
These settings are saved even if you turn the unit off.
Refer to page 14 for further notes and page 16 for error message explanations. (
“WARNING” may appears on the display during 
the detection here.)
Make sure your speaker settings match your connections (
 pages 13, and 14 to 16). There will be no output from a speaker if 
it is set as NO or NONE (
 page 27).
(Checks each speaker’s 
connection status)
(Shows the number of detected 
speakers, excluding the subwoofer)
(Shows connected speakers)
(Automatic speaker detection ends. 
The previous display reappears)
SA-XR58.indb   17
6/27/2006   6:55:04 PM