Panasonic ERRZ10 Operating Guide
10
English
Charging the trimmer
• Make sure that the trimmer is turned off.
1
Connect the appliance
plug to the stand socket.
2
Place the trimmer on the
charging stand.
3
Insert the adaptor into a
household outlet.
•Check that the charge status
lamp (
) glows.
•Charging is completed after
approx. 1 hour.
3
3
2
2
1
1
4
Disconnect the adaptor when the charge status
lamp stops glowing.
(for safety and to reduce energy usage)
<To check if charging is completed>
If you remove and reinsert the appliance plug while charging,
the charge status lamp glows and turns off after
approximately 5 seconds.
Notes
• If there is crackling noise on radios or other devices while
charging, charge the trimmer using a different household outlet.
• When the appliance is not used for 6 months or more, the battery
will weaken (leak battery fluid, etc.). Fully charge the battery
once every 6 months.
• When charging the trimmer for the first time or when it has not
been in use for more than 6 months, the lamp on the main body
may not glow for a few minutes, or the operating time may
shorten. Please charge it for more than 8 hours in such cases.
• Recommended ambient temperature for charging is 0 °C – 35 °C.
The charging time may change or battery performance may
decrease outside of the recommended temperature.
• A full charge supplies enough power for approximately
50 minutes of use. (When used on dry hair under 20 °C to 30 °C
environment for 20 minutes, once a week)
The operating time may differ depending on the frequency of
use, the operating method and the ambient temperature.
• You can charge the battery before it is completely discharged.
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
Charging without the charging stand
1. Press the power switch to turn off the power, and
insert the appliance plug into the trimmer.
2. Plug in the adaptor into a household outlet.
AC operation
If you connect the AC adaptor to the trimmer in the same way as
for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
ER-RZ10_EU.indb 10
2017/01/13 11:02:01