Panasonic DMREZ47VEB Operating Guide

59

RQT8857

 Tips

To browse through the list
Press [

  CH].

You can restart auto channel setting for terrestrial digital 
channels if set up (

¼ 10) fails for some reason.

However, if you perform “Auto-Setup Restart”, all channel 
settings and all created profi les are deleted.

] to select “Yes”, then press [OK].

 Tips

 You can also use the following method to restart Auto-

Setup. (All the settings except for the ratings level, 
ratings password, Owner ID and Clock return to the 
factory preset. The timer recording programmes are 
also cancelled.)

When the unit is turned on and stopped, press 
and hold [CH 

] and [CH ] on the main unit 

simultaneously for about 5 seconds.

Auto-Setup screen appears.

You can set channels manually if the DVB Auto Setup could 
not be completed successfully.

, ] to select the channel you want to set.

, ] to adjust the frequency.

–  The frequency rises and falls in steps of 0.5 MHz.
–  Adjust the frequency by checking the signal strength 

and signal quality displays.
[Refer to “Signal Condition” (

¼ right) for signal 

strength and signal quality.]

The set channel is displayed in the table.

 CH], check that 

You can search for newly added terrestrial digital channels to 
receive.

–  The unit starts searching for newly available terrestrial 

digital channels. This takes about 5 minutes.

–  The bar over the table shows you the search progress. 

At the end of the search, the number of found new 
digital stations appears.

–  “No new services found.”, is displayed when no new 

services can be found.

 Tips

To cancel in middle
Press [RETURN].
The channels found before stopping are not saved.

You can check the quality and strength of digital broadcast 
signals.
Realign the aerial if you are receiving a poor signal.
When “Signal Condition” is displayed in grey and cannot 
be selected:

1  Press [EXIT] to exit the screen.
2 Press 

[

  CH] to select a digital channel. “D” appears on 

the unit’s display.

3  Display the Setup menu again

The quality and strength of the signal are shown.
Press [

  CH] to select the channel.

Below 2 (display red):

The signal quality is so poor that 
there may be interference in the 
pictures and sound.

2–5 (display orange):

 The signal quality is basically 
adequate, but brief interference in 
the pictures and sound is possible 
in isolated case.

Over 5 (display green):

Optimum picture and sound quality.

Signal Strength
The display for signal strength is grey. “0” means signal 
strength 0%, “10” means signal strength 100%.
If the signal is too strong, the display will change from grey to red.
Reduce the signal amplifi cation at your aerial.

 When the signal is weak:

–  check that the aerial is correctly positioned
–  adjust the aerial reception with “DVB Manual Tuning” in 

the Setup menu (

¼ left).

–  check that the current digital broadcast channel is 

correctly broadcasting.

DMR-EZ47V_EB.indb   59

DMR-EZ47V_EB.indb   59

2007/04/11   9:13:29

2007/04/11   9:13:29