Panasonic DMREX89EB Operating Guide

71

RQT9463

Tips

To browse through the list
Press [  CH].

You can restart auto channel setting for digital terrestrial channels if 
the setup (  13) fails for some reason.
However, if you perform “DVB Auto Setup”, all channel settings and 
all the timer recording programmes are deleted. (All the settings 
except for the ratings level, ratings password, Owner ID, Clock and 
remote control code return to the factory preset.) Recordings on the 
HDD are not be deleted.
When the confi rmation screen appears
Press [] to select “Yes”, then press [OK].

Tips

 You can also use the following method to restart Auto-Setup. 
  When the unit is turned on and stopped, press and hold 

[CH ] and [CH ] on the main unit simultaneously for about 
5 seconds.

  –Auto-Setup screen appears.

You can set channels manually if the “DVB Auto Setup” could not be 
completed successfully.

1 Press [, ] to select the channel you want to set.

– Select the channel by checking the signal strength and signal 

quality displays.
[Refer to “Signal Condition” (  right) for signal strength and signal 
quality.]

The set channel is displayed in the 
table.

3 Press [EXIT], then press [ CH] to check that applicable 

You can search for newly added digital terrestrial channels to 
receive.

– The unit starts searching for newly available digital terrestrial 

channels. This takes about 5 minutes.

– The bar over the table shows you the search progress. At the end of 

the search, the number of found new digital stations appears.

– “No new DVB channels found.”, is displayed when no new channels 

can be found.

Tips

To cancel in middle
Press [RETURN  ].
The channels found before stopping are not saved.

You can check the quality and strength of digital broadcast signals.
Realign the aerial if you are receiving a poor signal.
When “Signal Condition” is displayed in grey and cannot be 
selected:
1 Press [EXIT] to exit the screen.
2 Press [  CH] to select a digital channel. “D” appears on the unit’s 

display.

3 Display the Setup menu again.

The quality and strength of the signal are shown.
Press [  CH] to select the channel.

Below 2 (display red)

The signal quality is so poor that there 
may be interference in the pictures and 
sound.

2–5 (display orange)

 The signal quality is basically adequate, 
but brief interference in the pictures and 
sound is possible in isolated case.

Over 5 (display green)

Optimum picture and sound quality.

Signal Strength
The display for signal strength is grey. “0” means signal strength 0%, 
“10” means signal strength 100%.
 If the signal is too strong, the display will change from grey to red. 

Reduce the signal amplifi cation at your aerial.

 When the signal is weak:

– check that the aerial is correctly positioned.
– adjust the aerial reception with “DVB Manual Tuning” in the Setup 

menu (  left).

– check that the current digital broadcast channel is correctly 

broadcasting.

Choose the audio language for digital broadcast.
If the selected language is not available, then the original language 
will be selected.
[English] [Welsh] [Gaelic] 

Choose the subtitle language for digital broadcast.
If the selected language is not available, then the original language 
will be selected.
[English] [Welsh] [Gaelic] 
[English for hearing impaired]
[Welsh for hearing impaired]
[Gaelic for hearing impaired]

DMR-EX79&89EB.indb   71

DMR-EX79&89EB.indb   71

2009/04/27   11:45:47

2009/04/27   11:45:47