Panasonic RX-ES29 Operating Guide

Page of 18
RQT7967
16
Troubleshooting
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies 
indicated in the chart do not solve the problem, refer to the “Product Information” on page 3.
Reference pages are shown in this way (
3).
Common problems
CD
Cassette deck
Radio
Remote Control
Specifications
Radio
Frequency range 
FM
87.9
s107.9 MHz (200 kHz steps)
 (ALT) 87.5
s108.0 MHz (100 kHz steps)
AM
520
s1710 kHz (10 kHz steps)
CD player
Sampling frequency 44.1 
kHz
Decoding
16 bit linear
Beam source
Semiconductor laser (wavelength 780 nm)
No. of channels
2-channel, stereo
Wow and flutter 
Below measurable limit
D/A converter
MASH (1 bit DAC)
Tape recorder
Track system Stereo
Monitor system
Variable sound monitor
Recording system
AC bias
Erasing system
Multi Pole magnet
Frequency range
Normal position
 50
s14000 Hz
General
Speakers 
8 cm 5.4 
™ k 2
Jacks
Output
PHONES: 3.5 mm stereo (16
s32 ™)
Power requirement
AC
120 V, 60 Hz
Power consumption:  32 W
Battery
12 V [Eight R20/LR20 (D, UM-1) batteries]
≥ Do not use rechargeable type batteries.
Memory back-up for computer/clock
6 V [Four R6/LR6 (AA, UM-3) batteries]
≥ Do not use rechargeable type batteries.
Dimensions
529 mm (W) 
k 144 mm (H) k 276 mm (D)
(20
13
/
16
q k 5
21
/
32
q k 10
7
/
8
q)
Mass
 4.2 k
g (9.3 lb) without batteries
Notes:
Specifications are subject to change without notice.
Mass and dimensions are approximate.
“E” is displayed.
Indicates incorrect operation. Read the instructions.
“U01” is displayed.
Replace the batteries or use household AC power. (
6)
“U02” is displayed.
Power batteries have not been inserted. Insert them or use household AC power. 
(
6)
CD will not play or CD display is 
incorrect.
Place the CD with label facing up. (
8)
Wait for 1 hour for condensation to dry and try again.
Certain sections are not played 
properly.
Clean the CD. (
2)
Replace the CD if it is scratched, warped, or nonstandard.
Recording is not possible.
If the cassette’s tabs have removed, cover the holes with adhesive tape. (
10)
Poor sound quality.
Clean the heads. (
15)
A lot of noise or tuning difficulty.
Interference may be caused by other equipment or the use of its remote control. 
Turn the other equipment off or keep this unit away from them.
The remote control does not work.
Check to ensure the batteries are inserted correctly. (
4)
Replace the batteries if they are worn. (
4)
The unit cannot be turned on from 
the remote control.
Turn the unit on from the main unit if you are using batteries to power the unit.
(
4, 6)
Power consumption in standby mode:
    2.7 W
RX-ES29-ad.book  16 ページ  2005年1月28日 金曜日 午前10時7分