Panasonic SC-HT928 Operating Guide

4

RQT7436

[Note]

The front and surround speaker pairs as well as the pipe pairs are 
different.
– Check the label on the rear of the speaker before attaching the 

pipe (

➜page 6).

– The pipe with the shorter cable is for the front speaker unit.

Preparation
≥To prevent damage or scratches, lay down a soft cloth and 

perform assembly on it.

≥For assembly, use a Phillips-head screwdriver.

1 Thread the speaker cable through the base.

2 Insert the pipe.

3 Secure the pipe to the 

Ensure the screw is 
securely fastened. 

≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
1 Remove the screw and separate the mounting plate into 

2 Attach plate A to the speaker.
Ensure that plate A is fastened on straight by lightly tightening the 
top and bottom screws alternately until fully tightened.

You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram 
(

➜ page 5) when attaching plate A to the upper rear or lower 

rear of the speaker.

3 Place the pipe on plate A and attach plate B.

4 Secure the plate with the same screw removed in 

Make sure you have all the indicated components before starting assembly, setup, and 
connection.

Lessen excess speaker cable.

Thread the 
speaker cable 
through here.

Insert the pipe while gently 
pulling on the speaker cable.

Rotate the pipe so that the flat 
side is facing away from the 
back of the speaker.

Fit the offset into the slot 
and slide plate B into the 
locked position.

7436en-p03-26.fm  4 ページ  ２００４年３月１６日　火曜日　午後４時８分