Panasonic KXHNS105E Operating Guide
Installation
Mount the siren on a wall using the
holes in the rear cover.
Note:
R The strobe light flashes when the
holes in the rear cover.
Note:
R The strobe light flashes when the
siren sounds. Mount the siren in a
location where its strobe light will be
visible.
location where its strobe light will be
visible.
R Mount the siren on the stable
location where the siren can be
adequately supported when
mounting.
adequately supported when
mounting.
R Mount the siren securely to a wall.
Vibrations may cause it to fall if it is
not secured.
not secured.
R Do not mount siren on a soft
material. It may fall down, break or
cause injury.
cause injury.
R Do not mount the siren on the
following places: gypsum board,
ALC (autoclaved lightweight cellular
concrete), concrete block, plywood
less than 25.4 mm thick, etc.
ALC (autoclaved lightweight cellular
concrete), concrete block, plywood
less than 25.4 mm thick, etc.
R Use only the supplied Panasonic AC
adaptor PNLV236E.
1
Remove the rear cover by
pressing the upper sides of the
cover (A) and sliding it down (B).
pressing the upper sides of the
cover (A) and sliding it down (B).
A
B
2
Attach the rear cover to the wall by
using screws (
using screws (
1
).
R Place the rear cover with “UP”
mark facing upwards.
R
2
37 mm
2
1
1
UP
UP
12
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
Setup
HNS105E_(en_en)_1228_ver.104.pdf 12
2016/12/28 11:34:59