Panasonic DVDS35EB Instruction Manual

Page of 48
Caution for AC Mains Lead
For your safety, please read the following text carefully.This appliance is supplied with a
moulded three pin mains plug for your safety and convenience.
A 5-ampere fuse is fitted in this plug. Should the fuse need to be replaced please ensure
that the replacement fuse has a rating of 5-ampere and that is approved by ASTA or BSI
to BS1362. Check for the ASTA mark
or the BSI mark
on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is refitted when the
fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement
cover is obtained. A replacement fuse cover can be purchased from your local dealer.
CAUTION!
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN
YOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF
AND DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL
SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13-AMPERE SOCKET.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code: Blue:
Neutral, Brown: Live.
As these colours may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows: The wire which is coloured Blue must be
connected to the terminal which is marked with the letter N or coloured Black or Blue.
The wire which is coloured Brown must be connected to the terminal which is marked
with the letter L or coloured Brown or Red.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH
IS MARKED WITH THE LETTER E, BY THE EARTH SYMBOL
OR COLOURED
GREEN OR GREEN/YELLOW. THIS PLUG IS NOT WATERPROOF - KEEP DRY.
CAUTION
1
1. Open the fuse cover with a screwdriver.
Fuse cover
Fuse
( 5 ampere)
2. Replace the fuse and attach the fuse cover.
How to replace the fuse
Confirm the AC mains plug fitted
and follow the instructions below.
Illustrations may differ from actual
AC mains plug.
2
FOR YOUR SAFETY DO NOT REMOVE OUTER COVER. To prevent electric shock,
do not remove the cover. There are no user serviceable parts inside. Refer all servicing
to qualified service personnel. For your safety, be sure not to connect or handle the
equipment with wet hands. BEFORE USE: Remove the connector cover.
5
If a new plug is to be fitted please observe the wiring code as stated below. If in any
doubt please consult a qualified electrician.