Panasonic CW-C120AU Operating Guide

Page of 9
14
AIR CONDITIONER OPERATION
OPERACIÓN DEL ACONDICIONADOR DE AIRE
AIR CONDITIONER OPERATION
OPERACIÓN DEL ACONDICIONADOR DE AIRE
1. Open the control panel cover
1. Abra la cubierta del panel de control
3. Main Control Knob
Set main control knob to the desired position.
3. Perilla del Control Principal
Ajuste la perilla del control principal, en la posición deseada.
4. Thermostat Control Knob
• For a room that is too warm, set the control knob to a clockwise direction.
• If the room is too cool, set the control knob to a counter clockwise direction.
Note : Usually 6~7 is the recommended setting position.
4. Perilla de Control de Termostato
• Para una habitación que está muy caliente, ajuste el perilla del control en la dirección de
las manecillas del reloj.
• Si la habitación está muy fria, ajuste el perilla del control en dirección contraria a las
manecillas del reloj.
Nota : Usualmente se recomienda una posición de ajuste entre 6~7.
CAUTION: If the main control knob is turned off or changed to a fan setting from a cooling
operation setting, WAIT at least 3 minutes before resetting it to a cooling operation.
CUIDADO: Si la perilla de control principal es apagada o cambiada a una posición de
ventilación de una función de enfriamiento, espere por lo menos tres minutos
antes de reajustar la perilla a una posición de enfriamiento.
ECONOMY
Recommended for electricity cost saving. Fan and compressor stop together when the room
temperature reaches the thermostat setting. They turn on again when the room temperature
rises. It may, however, take longer for the unit to cycle on again since the room air is not being
moved through the sensor by the fan.
Ahorramiento de costos recomendados. El ventilador y compresor se apagan juntos cuando
la temperatura de la habitación llega al nivel del termostato preajustado. Se encenderán
nuevamente cuando suba la temperatura en la habitación. Sin embargo puede tomar tiempo
para que la unidad nuevamente trabaje porque el ventilador no está moviendo el aire de la
habitación a través del sensor.
2. Power Supply
Switch off the breaker and set the main control knob to the OFF position; confirm that the
power supply cord is connected to a proper AC outlet. < 115V, 60Hz >
2. Suministro de Electricidad
Apague el interruptor y ponga el botón del control principal en posición OFF; confirme que
el cordón de la fuente de poder esta conectada a una salida correcta CA, <115V, 60Hz>.
5. Air Swing Switch
(Airflow direction adjustment Side-to-Side)
To obtain a fix airflow direction, set the air swing switch to “ON” for the vanes to swing
from side to side until the desired flow direction is reached, then switch it to “OFF”.
For continuous side-to-side air circulation, set the air swing switch to “ON”.
5. Interruptor de Rotado del Aire
(Ajuste de Lado a Lado de la dirección de corriente de aire)
Para obtener una mezcla de dirección del flujo del aire, ajuste el interruptor en “ON” hasta
balancear las veletas de lado a lado hasta que la dirección de flujo de aire deseado esta
alcanzada, entonces enchufe a “OFF”.
Para una circulación continua de lado a lado, ajuste el interruptor de Rotado del Aire en la
posición “ON”.
OFF
LOW
COOL
LOW
FAN
HIGH
FAN
MED
COOL
HIGH
COOL
THERMOSTAT
10
9
8
7
6
5
4
3
1
2
AIR SWING
ON
OFF
ECONOMY
OFF
LOW
COOL
LOW
FAN
HIGH
FAN
MED
COOL
HIGH
COOL
ECONOMY
THERMOSTAT
10
9
8
7
6
5
4
3
1
2
NOTE : Recommended setting
NOTA : Nivel recomendado
AIR SWING
ON
OFF
14