Panasonic TH-65PF20 Operating Guide
6
+
-
+
-
Accessories Supply
Accessories
Power supply cord
Clamper × 3
TMME289
TMME289
Ferrite core × 2
J0KG00000014
J0KG00000014
Batteries for the Remote
Control Transmitter
(R6 (UM3) Size × 2)
Control Transmitter
(R6 (UM3) Size × 2)
Remote Control
Transmitter
N2QAYB000432
Transmitter
N2QAYB000432
Operating Instruction book
Check that you have the accessories and items shown
Remote Control Batteries
Requires two R6 batteries.
1. Pull and hold the hook, then open
1. Pull and hold the hook, then open
the battery cover.
2. Insert batteries - note correct
polarity ( + and -).
3. Replace the cover.
Use the Ferrite cores to comply
with the EMC standard.
(see page 19)
with the EMC standard.
(see page 19)
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
“R6 (UM3)” size
CD-ROM
(Operating
instructions)
(Operating
instructions)