Panasonic KXTG1312CX Operating Guide
PNQW1081ZA
DC1008DC0
Frequently Asked Questions
What kind of power outlet should I
connect the AC adaptor to?
connect the AC adaptor to?
Connect the AC adaptor to a 220–240 V AC outlet.
How long should I charge the
batteries?
batteries?
Charge the batteries for about 7 hours. It takes 7 hours to fully
charge the batteries, however, you can use the handset before the
batteries are fully charged.
charge the batteries, however, you can use the handset before the
batteries are fully charged.
How long is the battery operating
time?
time?
When you are using fully-charged Ni-MH batteries (supplied
batteries);
In continuous use: 17 hours max.
Not in use (standby): 150 hours max.
L
batteries);
In continuous use: 17 hours max.
Not in use (standby): 150 hours max.
L
It is normal for batteries not to reach full capacity at the initial
charge. Maximum battery performance is reached after a few
complete cycles of charge/discharge (use).
charge. Maximum battery performance is reached after a few
complete cycles of charge/discharge (use).
L
Actual battery performance depends on a combination of how
often the handset is in use and how often it is not in use
(standby).
often the handset is in use and how often it is not in use
(standby).
Can I keep the handset on the
base unit or charger when I am
not using it?
base unit or charger when I am
not using it?
L
Even after the handset is fully charged, the handset can be left
on the base unit or charger without any ill effect on the batteries.
on the base unit or charger without any ill effect on the batteries.
When should I replace the
battery?
battery?
If the batteries are fully charged until 5 is displayed, but 7
is displayed after a few calls, replace the batteries with new ones.
is displayed after a few calls, replace the batteries with new ones.
How can I select tone or pulse
dialling mode?
dialling mode?
“1” (Tone): For tone dial service.
“2” (Pulse): For rotary/pulse dial service.
1 {j/OK}
2 {v}/{e}: “SETTING BS”
“2” (Pulse): For rotary/pulse dial service.
1 {j/OK}
2 {v}/{e}: “SETTING BS”
i
{>}
i
{3}
3 Enter base unit PIN (default: “0000”).
i
{1}
L
If you forget your PIN, contact your nearest Panasonic
service centre.
service centre.
4 Select the desired setting by pressing {1} for tone dialling mode
or {2} for pulse dialling mode.
5 {>}
i
{ih}
What is the handset or base unit
PIN?
PIN?
The PIN is a 4-digit number that must be entered in order to
change certain handset and base unit settings. The default PIN for
both the handset and base unit is “0000”.
change certain handset and base unit settings. The default PIN for
both the handset and base unit is “0000”.
What should I do to display caller
information?
information?
You must subscribe to a Caller ID service. Contact your service
provider/telephone company for details.
provider/telephone company for details.
TG1311_1312CX_FAQ_Leaflet.fm Page 1 Wednesday, October 8, 2008 11:36 AM