Panasonic CWSC120AA Operating Guide

1 Remove the front intake grille

Pull up the front intake grille about 90° and slide it
slightly to the left to unhook the tabs.

!"#$!%

!"# $%&'()*90° !"#$%&'()*

Tilt up and pull out the air
filter by the holder.
!"# !

!"#$%&'

CLOSE VENT O

PEN

2 Remove the air filter

!"#$

AIR CONDITIONER INSTALLATION

!"#

AIR CONDITIONER INSTALLATION

!"#

Installation Procedures
!"

CLOSE VENT

OPEN

;;;;;;;;;;;;;;;;;;;

;;;;;;;;;;;;;

;;;;;;;;;;;;

;;;;;;;;;;;;;;;;;;;

;;;;;;;;;;;;;

;;;;;;;;;;;;

;;;;;;;;;;;;;;;;;;;

;;;;;;;;;;;;;

;;;;;;;;;;;;

Air filter

Preparation Before Installation
!"#$%&

Dimension

• There should not be any obstacles surrounding the unit.
• Prepare an installation hole that is only slightly bigger than the cabinet

size.

• Left and right side of the unit should be at least 15cm away from the wall.

•

!"#$%&'()*+

•

!"#$%&'()*+,-

•

!"#$%&'"()15

Selecting The Best Location
!"#$

• Install the unit to the nearest power outlet.
• Power supply point shall be the place where there is ease for access for the power disconnection in case of

emergency.

• The air conditioner should be installed in a dry place where there are no draughts.
• Condensation from the air conditioner must be drained to an appropriate location.
• Do not install in a location where flammable gas leaks are a possibility.
• Usage in locations where the air is salty such as coastal areas or near hot spas, or where sulphurous gas is generated, may lead to

a malfunction. Please consult your dealer.

• Select an installation location which is rigid and strong enough to support or hold the unit and select a location for easy maintenance.

•

!"#$%&'()*+,-./

•

!"!#$%&'()$*%#+,-./012

•

!"#$%&'()*+,-.

•

!"#$%&'()*!+,-

•

!"#$%&'()*+,-./0

•

!"#$%&'()*+,-./01+23!4- 5$%6789:;<=>9:?@ABCDEFGHI$JKLA

•

!"#$%&'()*+,-./01234567 89

Fence

or likewise

Less than 24cm

er 5

WALL

61cm

Over 15cm

56cm

Over 15cm

37.5cm

CEILING

CLOSE VENT

OPEN

37.5

!"#

CLOSE VENT

OPEN

3 Remove the Front Grille

Remove the adhesive tapes from all sides of the front grille.

Open the control panel cover.

At bottom right side of front grille, press inward on cabinet near the power cord, and pull the
grille outward to the right until right tab releases.

At bottom left side, push inward on cabinet and pull the grille outward to the left to release the
left tab.
Do not pull the bottom edge toward you more than 3 inches as to prevent top two tabs from damage.

Slide the front grille upward to free the two top tabs from slots at the top of the cabinet.

a !"#$%&'

b !"#$%

c !"#$%&'()*+,-./0+12345(678(9':;<

d !"#$%&'"()*+,!-./012345678 !"#$%&'()*+,-./0

e !"#$%&'()* !"+,-./0

CW-PC120AA(09-13)

1/30/01, 10:59 AM