Panasonic KX-HCM10 Operating Guide
Operating Instructions
80
Digital Output Control
Digital Output Control window enables the digital output signal to activate the
external sensors/devices. (Open or Short to GND) The network administrator
should setup this setting.
external sensors/devices. (Open or Short to GND) The network administrator
should setup this setting.
Note
•
Please refer to Page 88 for additional technical specification.
•
Please refer to Section 3.1
Interfacing to the I/O Connector for details.
1.
Click [Digital Output Control] on the Setup Page.
2.
Check [Open] means the digital output terminal becomes high impedance
(open collector).
Check [Short to GND] means the digital output terminal becomes low (0V).
(open collector).
Check [Short to GND] means the digital output terminal becomes low (0V).
3.
Click [Save] when sending the signal.
•
Click [Cancel] to quit the current settings. It returns to the Setup Page
without saving the parameters.
without saving the parameters.