Panasonic KX-PS8000 Operating Guide

Page of 161
44
Setup
DCIS Standard System
If a SCSI-2 board has been installed in your computer, be sure it is compatible 
☞ 
P. 157 “SCSI Interface” specifications)
. If it is not installed, be sure to install only a
recommended SCSI-2 board 
☞ 
P. 16)
.
Recommendation for connecting DCIS:
B
We recommend you to connect your DCIS with only one SCSI device.
B
For a SCSI chain with up to three SCSI-2 (FAST SCSI) devices connected, the
total length of the SCSI cables must be less than 3 m (9.8 ft.).
B
Use shielded cables for SCSI-2 (FAST SCSI).
Note:
B
Although a SCSI chain may exceed the recommended length and still operate
we cannot guarantee this operation.
Make sure the computer, scanner, printer and the other
connected peripheral devices are turned off.
Connect the SCSI cable to the computer’s SCSI connector and to
the scanner’s SCSI connector A or B.
B
The SCSI-2 board must be installed in the computer.
If you do not have a SCSI-2 board or a SCSI cable, you will need to
purchase one from your local computer store or dealer 
☞ 
P. 16, 157 “SCSI
Interface” specifications)
.
Connect the SCSI cable provided to the printer’s SCSI connector
and to the scanner’s SCSI connector.
The printer must be the last device in the chain because the printer has only
one SCSI connector.
1
2
3
Computer’s 
SCSI connector