Panasonic KX-MB2575 Operating Guide

Page of 164
Problem
Cause & Solution
I cannot print a file saved on
the USB memory device.
R There is no USB memory device inserted in the unit. Insert a supported USB
R You tried to print different file formats onto 1 page. Activate the continuous
R The file may be broken. Try viewing the file on your computer.
R The file is too large or is in an unsupported format. Use a supported file
12.4.7 Network (LAN supported models only) y
Problem
Cause & Solution
I cannot operate the following
functions.
– PC printing
– Scanning
– Remote Control
– PC FAX (y)
– Device Monitor
R Confirm the LED via the LAN port of the main board. If the LED is glowing
or blinking, network access is working correctly.
If the LED is not glowing or blinking, confirm the LAN cable (Category 5
(Cat-5) Ethernet cable) is connected to the LAN port of the main board
correctly.
R If the LED is blinking and you cannot perform the desired operation, the IP
address of the unit may have changed.
To detect the IP address, click [IP Change] in the connection error message
dialogue.
R The IP address for the unit will be detected.
Note:
R If the IP address cannot be detected, enter it manually (feature #501 on
page 91). The IP address of the computer and the unit must be in the
same local IP address class as shown below. Set the IP address in the
range of the number specified in the class corresponding to your local
network scale.
Class
Subnet mask
IP address
Class A
255.0.0.0
10.0.0.1 -
10.255.255.254
Class B
255.255.0.0
172.xx.0.1 - 
172.xx.255.254
Class C
255.255.255.0
192.168.xx.1 -
192.168.xx.254
*1 “xx” should be the same value for the unit and for the computer,
as shown in the following example.
Example: 172.16.0.1 - 172.16.255.254
(The available range of “xx” is 16 - 31)
*2 “xx” should be the same value for the unit and for the computer,
as shown in the following example.
Example: 192.168.0.1 - 192.168.0.254
(The available range of “xx” is 0 - 255)
R Your firewall software is blocking the connection. Disable the firewall
software or change the firewall settings to make the Multi-Function Station
work properly.
R If feature #580 has been set to “OFF”, change the setting to “WIRED” or
“WIRELESS”. If feature #580 has been set to “WIRELESS”, refer to
“12.4.8  Wireless LAN y” on page 123.
R Make sure the network is configured correctly. Consult your network
administrator.
122
12. Help