Panasonic KX-MB2575 Operating Guide

#526

#532

When “ENABLED” is selected, the unit will deny/approve access from the
pre-programmed IP patterns. You can program whether to deny or approve IP
addresses. Up to 4 patterns each for IPv4 and IPv6 can be programmed through
the web browser interface (page 99).
M0N “DISABLED” (default)
M1N “ENABLED”

#533

To set the IP address automatically for the LAN connection. This feature is
available when feature #500 is activated. When “ENABLED” is selected, IP
address will be allocated automatically without using a DHCP (Dynamic Host
Configuration Protocol) server.
M0N “DISABLED” (default)
M1N “ENABLED”

#534

To set HTTPD for the LAN connection. When “ENABLED” is selected, you can
access to the web server.
M0N “DISABLED”
M1N “ENABLED” (default)

#535

When “ENABLED” is selected, IPv6 protocol can be used. After installing the
printer driver, be sure to change the port to IPv6 protocol. You can check the IPv6
protocol address by printing the “SETUP LIST” (page 103).
M0N “DISABLED” (default)
M1N “ENABLED”

Note:
R To activate this feature, you need to turn the power switch of the unit OFF,

then ON.

#538

To set the primary WINS server for the LAN connection. This feature is available
when feature #500 is deactivated.
1. MtN A MBNM5NM3NM8N A MOKN
2. Enter the primary WINS server of the network on the LAN using the dial

keypad. A MOKN A MtN

#539

To set the secondary WINS server for the LAN connection. This feature is
available when feature #500 is deactivated.
1. MtN A MBNM5NM3NM9N A MOKN
2. Enter the secondary WINS server of the network on the LAN using the dial

keypad. A MOKN A MtN

#567

When “ENABLED” is selected, you can check and edit the address book through
the web browser interface.
M0N “DISABLED”
M1N “ENABLED” (default)

#569

When “ENABLED” is selected, you can check the journal report through the web
browser interface (page 104).
M0N “DISABLED”
M1N “ENABLED” (default)

92