Panasonic DPMB300EU Operating Guide
3. Preparation
22
Volume
3.7 Adjusting the volume
Important:
L
Before adjusting the volume, set the operation
mode to fax mode. If the {
mode to fax mode. If the {
K} light is OFF, turn it
ON by pressing {
K}.
Ringer volume
While the unit is idle, press {V} or {^}.
While the unit is idle, press {V} or {^}.
L
The ringer volume can only be adjusted if there are
no documents in the document feeder entrance.
no documents in the document feeder entrance.
To turn the ringer OFF
Press {V} repeatedly to display “
Press {V} repeatedly to display “
RINGER OFF= OK?”.
i {OK}
L
The unit will not ring.
L
To turn the ringer back ON, press {^}.
Monitor volume
While using the monitor, press {V} or {^}.
While using the monitor, press {V} or {^}.
Initial Programming
3.8 Date and time
We recommend you to set the date and time. The other
party will receive your unit’s date and time as the header
information.
party will receive your unit’s date and time as the header
information.
1
{
Y} i {#}{1}{0}{1} i {OK}
D:
|
01/M:01/Y:09
TIME: 00:00
2
Enter the current date/month/year/hour/minute by
selecting 2 digits for each. Press {*} repeatedly to
select “
selecting 2 digits for each. Press {*} repeatedly to
select “
AM” or “PM”, or 24-hour time entry.
Example: 10 August, 2009 10:15 PM (12 hour
clock format)
clock format)
1. Press {1}{0} {0}{8} {0}{9} {1}{0} {1}{5}.
D:
|
10/M:08/Y:09
TIME: 10:15
2. Press {*} repeatedly to select “
PM”.
3
{
OK}
4
Press {
Y} to exit.
Note:
L
To check the current date and time setting, press
{
{
K} to temporarily change the unit to the fax mode.
L
Your unit’s date and time will be used as the header
information for the following:
–
information for the following:
–
When sending as an attached file to an email
destination directly from this unit (Scan to email
address) (page 33).
destination directly from this unit (Scan to email
address) (page 33).
–
When sending faxes (page 43).
L
If the date and time is not set correctly, the other
party will receive an incorrect date and time as their
header. This may confuse the other party.
party will receive an incorrect date and time as their
header. This may confuse the other party.
To correct a mistake
Press {<} or {>} to move the cursor to the incorrect
number, and make the correction.
Press {<} or {>} to move the cursor to the incorrect
number, and make the correction.
{
K} (Fax)
{
V}{^}
{
OK}
{
OK}
{
Y} (Menu)
{<}{>}
{
K} (Fax)