Panasonic KX-MB1520 Operating Guide

R Unplug this unit from power outlets and refer servicing to an authorized

service center when any of the following conditions occur:
–

If the power cord is damaged or frayed.

–

If the unit has been exposed to rain or water, or liquid has been
spilled into the unit. Do not use a microwave oven to speed up the
drying process of any parts of the unit to avoid permanent damage.

–

If the unit does not work normally by following the operating
instructions. Adjust only controls covered by the operating
instructions. Improper adjustment may require extensive work by
an authorized service center.

–

If the unit has been dropped or physically damaged.

–

If the unit exhibits a distinct change in performance.

USB cable
R To assure continued emission limit compliance, use only shielded USB

cable (Example: Hi-Speed USB 2.0 certified cable).

Installation and relocation
R After moving the unit from cold areas to warmer areas, wait

approximately 30 minutes before turning on the power switch to allow
the unit to adjust to the ambient temperature. If the power switch is
turned on too soon after a sudden climate change, condensation may
form inside the unit, causing malfunction.

R Never turn the unit upside down or sideways when moving it.
R Never install telephone wiring during a lightning storm (KX-MB1520

only).

R Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations (KX-MB1520 only).

R Never touch uninsulated telephone wires or terminals unless the

telephone line has been disconnected at the network interface
(KX-MB1520 only).

R Use caution when installing or modifying telephone lines (KX-MB1520

only).

R Do not position the unit in a location where it is unstable or subject to

vibrations.

CLASS 1 LASER PRODUCT

R The printer of this unit utilizes a laser. Use of controls or adjustments

or performance of procedures other than those specified herein may
result in hazardous radiation exposure.

See the operating instructions for the Laser diodes properties.

CLASS 1 LED PRODUCT

R When using the unit, do not look directly at the CIS’s LED light. Direct

eye exposure can cause eye damage.

See the operating instructions where the CIS LED specifications are
listed.

Fuser unit
R During or immediately after printing, the fuser unit gets hot. This is

normal. Do not touch the fuser unit.

Note:
R The area near the rear cover may also get warm. This is normal.

Toner cartridge
R Avoid ingestion, inhalation, eye or skin contact.

–

If ingestion occurs, drink several glasses of water to dilute stomach
contents.

–

If inhalation occurs, exit the area immediately into an area with
fresh air.

–

If skin contact occurs, wash thoroughly with soap and cold water,
then air dry. Do not use hot water or hair dryer.

–

If eye contact occurs, flush thoroughly with water.

–

In all cases, seek medical treatment if adverse symptoms occur.

When using this unit, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, or personal injury.

1. Do not use this unit near water, for example near a bathtub, wash bowl,

kitchen sink, etc.

2. During thunderstorms, avoid using telephones except cordless types.

There may be a remote risk of an electric shock from lightning
(KX-MB1520 only).

3. Do not use the telephone of this unit (if so equipped) to report a gas

leak, when in the vicinity of the leak (KX-MB1520 only).

R It is unlawful to make copies of certain documents.

Copying certain documents may be illegal in your country. Penalties of
fines and/or imprisonment may be imposed on those found guilty. The
following are examples of items that may be illegal to copy in your
country.
–

Currency

–

Bank notes and checks

–

Bank and government bonds and securities

–

Passports and identification cards

–

Copyright material or trademarks without the consent of the owner

–

Postage stamps and other negotiable instruments

Notice:
R Install your machine near a supervised area to prevent illegal copies

from being made.

Detailed operating instructions are on the CD-ROM, or can be viewed at www.panasonic.com/help

3