Panasonic KX-MC6020 Operating Guide
Important Information
4
Detailed operating instructions are on the CD-ROM, or can be viewed at www.panasonic.com/help
Operating safeguards
Installation and relocation
Make sure that the unit is installed in a well
ventilated room so as not to increase
density of ozone in the air. Since ozone is
heavier than air, it is recommended that air
at floor level be ventilated.
ventilated room so as not to increase
density of ozone in the air. Since ozone is
heavier than air, it is recommended that air
at floor level be ventilated.
Turn the power switch OFF before cleaning.
Do not use liquid or aerosol cleaners.
Do not use liquid or aerosol cleaners.
Do not cover slots and openings on the unit.
They are provided for ventilation and
protection against overheating. Never place
the unit near radiators, or in a place where
proper ventilation is not provided.
They are provided for ventilation and
protection against overheating. Never place
the unit near radiators, or in a place where
proper ventilation is not provided.
Never push any objects through slots in this
unit. This may result in the risk of fire or
electric shock. Never spill any liquid on the
unit.
unit. This may result in the risk of fire or
electric shock. Never spill any liquid on the
unit.
To reduce the risk of electric shock, do not
disassemble this unit. Take the unit to an
authorized service center when service is
required. Opening or removing covers may
expose you to dangerous voltage or other
risks. Incorrect reassembly can cause
electric shock when the unit is subsequently
used.
disassemble this unit. Take the unit to an
authorized service center when service is
required. Opening or removing covers may
expose you to dangerous voltage or other
risks. Incorrect reassembly can cause
electric shock when the unit is subsequently
used.
Follow all warnings and instructions marked
on this unit.
on this unit.
Do not spill liquids (detergents, cleansers,
etc.) onto the telephone line cord plug, or
allow it to become wet at all. This may cause
a fire. If the telephone line cord plug
becomes wet, immediately pull it from the
telephone wall jack, and do not use.
etc.) onto the telephone line cord plug, or
allow it to become wet at all. This may cause
a fire. If the telephone line cord plug
becomes wet, immediately pull it from the
telephone wall jack, and do not use.
Unplug this unit from power outlets and refer
servicing to an authorized service center
when any of the following conditions occur:
servicing to an authorized service center
when any of the following conditions occur:
L
If the power cord is damaged or frayed.
L
If liquid has been spilled into the unit.
L
If the unit has been exposed to rain or
water.
water.
L
If the unit does not work normally by
following the operating instructions.
Adjust only controls covered by the
operating instructions. Improper
adjustment may require extensive work
by an authorized service center.
following the operating instructions.
Adjust only controls covered by the
operating instructions. Improper
adjustment may require extensive work
by an authorized service center.
L
If the unit has been dropped or
physically damaged.
physically damaged.
L
If the unit exhibits a distinct change in
performance.
performance.
After moving the unit from cold areas to
warmer areas, let the unit adjust to the
warmer temperature and do not turn on the
power switch for about 30 minutes. If the
power switch is turned on too soon after a
sudden climate change, condensation may
form inside the unit, causing malfunction.
warmer areas, let the unit adjust to the
warmer temperature and do not turn on the
power switch for about 30 minutes. If the
power switch is turned on too soon after a
sudden climate change, condensation may
form inside the unit, causing malfunction.
Never turn the unit upside down or sideways
when moving it.
when moving it.
Never install telephone wiring during a
lightning storm.
lightning storm.
Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
locations unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone wires or
terminals unless the telephone line has
been disconnected at the network interface.
terminals unless the telephone line has
been disconnected at the network interface.
Use caution when installing or modifying
telephone lines.
telephone lines.
Do not position the unit in a location where it
is unstable or subject to vibrations.
is unstable or subject to vibrations.
MC6020-PNQW1048ZA-QRG-en.book Page 4 Tuesday, May 20, 2008 2:09 PM