Panasonic KXTCD203E Operating Guide
Preparation
8
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Displays
Display icons
Various icons appear on the handset display
to indicate the current status of the unit.
Various icons appear on the handset display
to indicate the current status of the unit.
Connections
When the AC adaptor is connected, a short
beep will be heard. If it is not heard, check
the connections.
beep will be heard. If it is not heard, check
the connections.
Important:
L
Use only the AC adaptor and telephone
line cord supplied with this unit.
line cord supplied with this unit.
Note:
L
If the AC outlet is connected to a switch,
make sure the switch is on.
make sure the switch is on.
L
After connection, you must charge the
batteries to make or answer calls (page
9).
batteries to make or answer calls (page
9).
L
Never install telephone wiring during a
lightning storm.
lightning storm.
L
The AC adaptor must remain connected
at all times. (It is normal for the adaptor to
feel warm during use.)
at all times. (It is normal for the adaptor to
feel warm during use.)
L
The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
Display
icon
icon
Meaning
w
Within range of a base unit
L
When flashing: Handset
is searching for base unit.
(out of range of base unit,
handset is not registered
to base unit, no power on
base unit)
is searching for base unit.
(out of range of base unit,
handset is not registered
to base unit, no power on
base unit)
L
Handset is accessing base
unit. (intercom, paging,
changing base unit settings,
etc.)
unit. (intercom, paging,
changing base unit settings,
etc.)
k
Handset is on an outside
call.
call.
o
Call bar is on. (page 22)
5
Battery strength
[VE]
Voice enhancer is set to
high or low tone. (page 13)
high or low tone. (page 13)
[N]
Night mode is on. (page 20)
[X]
Key lock is on. (page 13)
[2]
-2-
Base unit number: The left
icon shows base unit 2
example. (page 21)
Line is being used by
another handset.
icon shows base unit 2
example. (page 21)
Line is being used by
another handset.
(220
–
240 V, 50 Hz)
To telephone
network
network
Hooks
TCD200E(e-e).book Page 8 Wednesday, February 9, 2005 2:58 PM