Panasonic KXTGB212FX Operating Guide
Useful Information
27
Error messages
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
General use
Display message
Cause/solution
Memory Full
L
The phonebook memory is full. Erase unwanted entries (page
16).
16).
Problem
Cause/solution
The handset does not turn on even
after installing charged batteries.
after installing charged batteries.
L
Place the handset on the base unit or charger to turn
on the handset.
on the handset.
The unit does not work.
L
Make sure the batteries are installed correctly (page
9).
9).
L
Fully charge the batteries (page 9).
L
Check the connections (page 9).
L
Unplug the base unit’s AC adaptor to reset the unit
and turn off the handset. Reconnect the adaptor, turn
on the handset and try again.
and turn off the handset. Reconnect the adaptor, turn
on the handset and try again.
L
Remove the batteries from the handset and install
again.
again.
L
The handset has not been registered to the base
unit. Register the handset (page 30).
unit. Register the handset (page 30).
The handset display is blank.
L
The handset is not turned on. Turn the power on
(page 12).
(page 12).
I cannot hear a dial tone.
L
Make sure that you are using the supplied telephone
line cord. Your old telephone line cord may have a
different wiring configuration.
line cord. Your old telephone line cord may have a
different wiring configuration.
L
The base unit’s AC adaptor or telephone line cord is
not connected. Check the connections.
not connected. Check the connections.
L
Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our
service personnel to have the unit repaired. If the
working telephone does not operate properly,
contact your service provider/telephone company.
connect the line to a known working telephone. If the
working telephone operates properly, contact our
service personnel to have the unit repaired. If the
working telephone does not operate properly,
contact your service provider/telephone company.
TGB21xFX(en).book Page 27 Friday, March 21, 2014 4:22 PM