Panasonic EP3205R2 Operating Guide

Page of 17
39
Attaching the Armrests
Align the 
o
marks.
Control
Panel Stand
Allen Key (provided)
Slide the armrest
forward until the 
p
aligns with the 
A
.
1. Insert the armrests into
the seat.
• Marks indicating left and right can
be found on the underside of each
armrest.
Attaching the Control Panel Stand
Secure the control panel stand to the right hand side of the unit using the three
screws provided. 
Attaching and Removing the Control Panel
When attaching the
control panel, slide
it in from the top.
Slide the control panel
up to remove it.
• Loosen the screw to situate the
control panel stand at the desired
angle, then tighten screw again.
For smooth removal of the
control panel, press on the back
of the unit while sliding up.
2. Push the armrest
forward until it clicks
into position. 
3. Insert the attachment
screw into the hole and use
the Allen key to secure it.
(Repeat the procedure for the armrest
on the other side.)
Clip
Screw
Turn the screw
clockwise to
tighten it.
38
SETTING UP THE MASSAGE LOUNGER
BEFORE USING THE UNIT
Ensure there is adequate space for reclining
• Do not use the massage lounger in direct sunlight
or in places where it will be exposed to high
temperatures, such as in front of a heater, etc., as
this can cause discoloration or hardening of the
synthetic leather.
• Place the unit on a mat to prevent floor damage.
After removing everything from the box, you should have the following
Where to Use the Unit
Massage Lounger
Accessories
Armrest 
Marks indicating left and right
can be found on the underside
of each armrest.
Control Panel Stand
Pillow
Front
Front
Back
Left
Right
Back
Attachment Screws (M6
#
10) – 5
Control Panel Stand – 3
Left Armrest – 1
Right Armrest – 1
Allen Key
At Least 40 cm
Mat
At Least 40 cm
CAUTION
• Do not use the unit in areas with high humidity,
such as the bathroom, etc. as this can lead to
electric shock or other accidents.
• Do not allow children to play on the unit.  Doing
so may lead to accidents or injury.
• Place the unit on a totally flat surface.
Failure to do so may result in the seat tipping over.