Panasonic rc-sc90y Operating Guide
11
CLOSE VENT
OPEN
CLOSE VENT
OPEN
Slide the front intake grille slightly to the right to reattach
the tabs and then push down to close tight.
the tabs and then push down to close tight.
NOTE: A “click” sound can be heard when the front intake grille
is pushed down.
“
”
Electrical work
• Always use at the rated voltage and with a specific air
conditioning circuit.
• Some installation locations may require installation of a
shortcircuit breaker.
• A 16 Ampere time delay fuse or circuit breaker is required.
• Nominal cross sectional area of power supply wire must be
• Nominal cross sectional area of power supply wire must be
3 core x 1.5 mm
2
or above.
• The power supply must be from an independent circuit.
• All electrical installation must be made in accordance with local
• All electrical installation must be made in accordance with local
wiring and safety regulations wherever applicable.
• There must be a double pole switch with minimum 3mm contact
gap in the fixed installation circuit. (Applicable for models without
power supply plug only.)
power supply plug only.)
• Please consult your dealer concerning installation requirements.
Å Reattach the front intake grille
Å
Å
Ä Insert the air filter
Ä
Ä
Lift up
about 90°.
about 90°.
90°
•
•
•
•
•
16
•
3
x 1.5
•
•
•
•
3
(
)
•
Remove the air filter procedures
CLOSE VENT
OPEN
1 Push and release the bottom of the
front intake grille.
2 Lift up the front intake grille at 45°
until it is supported by the stopper.
3 Tilt up and pull out the air filter
by the holder.
1
2
45°
3
Stopper
8 Lock the chassis to the cabinet by using
back the chassis locking brackets
8
9 Reattach the front grille to the cabinet
and secure it with screws
9
Clockwise
Depending upon the location of the AC
outlet, route the AC cord to either left or
right side while installing the front grille.
outlet, route the AC cord to either left or
right side while installing the front grille.
11
RC-PC70/90Y(09-13)
1/30/01, 11:01 AM
11