Panasonic KXTG8024E Operating Guide

– 5 –

Why is w flashing?

L

The handset is too far from the base unit. Move 
closer.

L

The base unit’s AC adaptor is not connected. 
Check the connections.

L

You are using the handset or base unit in an area 
with high electrical interference. Re-position the 
base unit and use the handset away from sources 
of interference.

L

The handset is not registered to the base unit. 
Register it (page 7).

Why is the handset display 
blank or goes dark when on 
a call?

L

The handset is in screen saver mode. Activate the 
handset display again by:
– pressing {<} or {>} when on a call.
– pressing {ih} at all other times.

L

” is set to “

” while on charge. 

Change the setting.

What should I do when the 
handset does not turn on?

L

Make sure the batteries are installed correctly. 

L

Fully charge the batteries.

L

Clean the charge contacts and charge again.

How long is the battery 
operating time?

L

When you are using fully-charged Ni-MH batteries 
(supplied batteries);
In continuous use: 14 hours max.
Not in use (standby): 240 hours (10 days) max.

L

It is normal for batteries not to reach full capacity 
at the initial charge. Maximum battery 
performance is reached after a few complete 
cycles of charge/discharge (use).

L

Actual battery performance depends on a 
combination of how often the handset is in use 
and how often it is not in use (standby).

Can I keep the handset on 
the base unit or charger 
when I am not using it?

L

Even after the handset is fully charged, the 
handset can be left on the base unit or charger 
without any ill effect on the batteries.

When should I replace the 
batteries?

L

If the batteries are fully charged until 1 is 
displayed, but 3 is displayed after a few calls, 
replace the batteries with new ones.

What is a PIN?

L

The PIN is a 4-digit number that must be entered 
in order to change certain base unit settings. The 
default PIN is “

”.

TG8021E(e)_QG.fm  Page 5  Thursday, May 29, 2008  3:56 PM