Panasonic KXMB781 Operating Guide

Page of 20
Important Information
4
Detailed operating instructions are on the CD-ROM, or can be viewed at www.panasonic.com/help
Operating safeguards
Installation and relocation
Make sure that the unit is installed in a well 
ventilated room so as not to increase 
density of ozone in the air. Since ozone is 
heavier than air, it is recommended that air 
at floor level be ventilated.
Unplug this unit from power outlets before 
cleaning. Do not use liquid or aerosol 
cleaners.
Do not cover slots and openings on the unit. 
They are provided for ventilation and 
protection against overheating. Never place 
the unit near radiators, or in a place where 
proper ventilation is not provided.
Never push any objects through slots in this 
unit. This may result in the risk of fire or 
electric shock. Never spill any liquid on the 
unit.
To reduce the risk of electric shock, do not 
disassemble this unit. Take the unit to an 
authorized service center when service is 
required. Opening or removing covers may 
expose you to dangerous voltage or other 
risks. Incorrect reassembly can cause 
electric shock when the unit is subsequently 
used.
Follow all warnings and instructions marked 
on this unit.
Do not spill liquids (detergents, cleansers, 
etc.) onto the telephone line cord plug, or 
allow it to become wet at all. This may cause 
a fire. If the telephone line cord plug 
becomes wet, immediately pull it from the 
telephone wall jack, and do not use (KX-
MB781 only).
Unplug this unit from power outlets and refer 
servicing to an authorized service center 
when the following conditions occur:
 
L
If the power cord is damaged or frayed.
L
If liquid has been spilled into the unit.
L
If the unit has been exposed to rain or 
water.
L
If the unit does not work normally by 
following the operating instructions. 
Adjust only controls covered by the 
operating instructions. Improper 
adjustment may require extensive work 
by an authorized service center.
L
If the unit has been dropped or 
physically damaged.
L
If the unit exhibits a distinct change in 
performance.
After moving the unit from cold areas to 
warmer areas, let the unit adjust to the 
warmer temperature and do not connect the 
unit for about 30 minutes. If the unit is 
connected too soon after a sudden climate 
change, condensation may form inside the 
unit causing malfunction.
Never install telephone wiring during a 
lightning storm (KX-MB781 only).
Never install telephone jacks in wet 
locations unless the jack is specifically 
designed for wet locations (KX-MB781 
only).
Never touch uninsulated telephone wires or 
terminals unless the telephone line has 
been disconnected at the network interface 
(KX-MB781 only).
Use caution when installing or modifying 
telephone lines (KX-MB781 only).
MB271-781-PFQW2640ZA-QRG-en.book  Page 4  Tuesday, May 22, 2007  12:31 PM