Panasonic PT-L780NTE Operating Guide

NOTE:
B S1 video signals

S1 video signals are a type of video
signal with an aspect ratio of 16:9
which include a detector signal. This
detector signal is output by some
sources such as wide-vision video
decks. If the AUTO setting above is
selected, this projector will recognise
the detector signal and automatically
switch the aspect ratio to 16:9 in
order to project the picture.

B This projector is equipped with an

aspect ratio selection function.
However, if a mode which does
not match the aspect ratio of the
input signal is selected, it may
affect the quality of viewing of the
original picture. Keep this in mind
when selecting the aspect ratio.

B If using this projector in places

such as cafes or hotels with the
aim of displaying programmes for
viewing for a commercial purpose
or for public presentation, note
that if the aspect ratio (16:9)
selection function is used to
change the aspect ratio of the
screen picture, you may be
infringing the rights of the original
copyright owner for that
programme under copyright
protection laws.

B If a normal (4:3) picture which

was not originally intended for
wide-screen viewing is projected
onto a wide screen, distortion
may occur around the edges of
the picture so that part of the
picture is no longer visible. Such
programmes should be viewed in
4:3 mode to give proper
consideration to the aims and
intentions of the original
programme’s creator.

BWhen a VGA60 or 525p RGB

signal is being input, select the
signal in accordance with the
input signal.

This should normally be set to “ON”.
(This setting is only for signals
which have lower resolutions than
the LCD panels. Refer to page 61
for details.)

ON
The pixel resolution of the input
signal is converted to the same
resolution as the LCD panels before
being projected. For signals with
lower resolutions, gaps in the pixels
are automatically interpolated into
the picture before it is projected.
This may sometimes cause
problems with the quality of the
picture.

OFF
The picture signal is projected at its
original resolution, with no pixel
conversion. The projected picture
will be smaller than normal, so
adjust the zoom setting or move the
projector forwards or backwards to
adjust the picture size if necessary.
If set to “OFF”, some features, such
as D.ZOOM (digital zoom) or
keystone distortion correction will
not function.

This item functions in the same way
as the AUTO SETUP button on the
remote control unit. (page 14)

If the picture’s condition is bad while
a RGB moving picture signal is
projected, set the FRAME LOCK to
“ON”. Refer to page 61 on
compatible RGB signals.

Select the items by pressing the F
or G buttons on the remote control
unit or the projector.

Press the I or H buttons to adjust
the volume of the sound output by
the projector’s built-in speakers. 

Set the MUTE to “ON” pressing the
I or H buttons to turn off the
volume of the sound output.
To release muting, set to “OFF”
pressing the I or H buttons.

AUDIO

VOLUME

MUTE

OFF

ON

20

SELECT:[^][@]

ADJUST:[{][}]

ENTER:[ENTER]

ESC:[MENU]

Use the F and G buttons on the projector or remote control unit to select a
language, then press the MENU button to accept the setting.

ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL

ITALIANO

LANGUAGE

SELECT:[^][@]

[{][}]

ADJUST:[{][}]

ENTER:[ENTER]

  ESC:[MENU]